
Assembly & Operating Instructions
18" Outdoor Air Circulators
CAUTION: Read and follow all instructions before operating fan. Do not use
fan if any part is damaged or missing.
WARNING: To reduce the risk of electrical shock, do not use this fan with
any solid state speed control device.
This appliance has a 3-prong grounded plug and must be inserted into a
matching grounded GFI outlet for safe operation and to reduce the risk of
electrical shock.
RULES FOR SAFE OPERATION
• Never insert fingers or any other objects through the grill guard when fan is
in operation.
• Unplug the fan when moving from one location to another.
• Unplug the fan when removing guards for cleaning.
• Do not use with an extension cord.
• Do not place fan or any parts near an open flame, cooking or other heating
appliance.
• DO NOT use fan in windows.
ASSEMBLY INSTRUCTIONS
Wall or Ceiling Mounting - Permanent Mounting Only
1. Locate solid wall stud or ceiling beam. Mark the center of the beam. If you
do not have a solid structural framing member at that location then you
must provide an adequate alterative for mounting the fan.
2. Drill pilot hole for 3/8" lag bolt.
3. Secure with the hardware provided.
NOTE: Plug fan into a GFI outlet to ensure safety.
OPERATION INSTRUCTIONS
To adjust airflow upward or downward: Tilt the fan head to the desired angle.
This high velocity fan can be used alone or in conjunction with air conditioning.
Rotating the fan head upward serves to pull air from the floor and circulate it
throughout the entire room.
Speed Control: Rotate Switch to Low or High speeds for respective air velocity.
It is normal for the motor to feel warm to touch after continuous operation. This
fan features a thermostat that will automatically shut off should it overheat for
any reason. If this happens, immediately unplug the fan from the outlet.
CLEANING
WARNING: Unplug from electrical supply source before cleaning. After
servicing, any safety device (including grills and blades) must be reinstalled or
remounted as previously installed. Use soft damp cloth then wipe with dry cloth.
Do not use harmful cleaners. Do not bend the blades. The motor bearings are
permanently sealed and do not require additional lubrication.
THIS PAGE INTENTIONALLY
LEFT BLANK