Pioneer GEX-1550DTV User manual

<127075004506> <1>
Owner’s Manual
Manual do Proprietário
Manual de instrucciones
HIDEAWAY 1SEG DIGITALTV TUNER
MÓDULO SINTONIZADOR DE TV DIGITAL 1SEG
GEX-1550DTV
English
Português (B)
Español

Black plate (2,1)
Thank you for purchasing this PIONEER product.
To ensure proper use, please read through this manual before using this product.
Please keep the manual in a safe and accessible place for future reference.
Precautions
IMPORTANT SAFEGUARDS 3
To avoid battery exhaustion 3
Before you start
About this unit 4
About this manual 4
Resetting the microprocessor 4
Connections
Connecting the units 6
Additional information
Specifications 7
<127075004506>2
Contents
En
2

Black plate (3,1)
IMPORTANT SAFEGUARDS
Please read all of these instructions regarding
your display and retain them for future refer-
ence.
1Do not install the display where it may (i)
obstruct the driver’s vision, (ii) impair the
performance of any of the vehicle’s oper-
ating systems or safety features, includ-
ing air bags, hazard lamp buttons or (iii)
impair the driver’s ability to safely oper-
ate the vehicle.
2Do not operate this display if doing so in
any way will divert your attention from
the safe operation of your vehicle. Always
observe safe driving rules and follow all
existing traffic regulations. If you experi-
ence difficulty in operating the system or
reading the display, park your vehicle in a
safe location and make necessary adjust-
ments.
3Please remember to wear your seat belt at
all times while operating your vehicle. If
you are ever in an accident, your injuries
can be considerably more severe if your
seat belt is not properly buckled.
4Never use headphones while driving.
5To promote safety, certain functions are
disabled unless the parking brake is on,
and the vehicle is not in motion.
6Never set the volume of your display so
high that you cannot hear outside traffic
and emergency vehicles.
WARNING
Do not attempt to install or service your dis-
play by yourself. Installation or servicing of
the display by persons without training and
experience in electronic equipment and auto-
motive accessories may be dangerous and
could expose you to the risk of electric shock
or other hazards.
To avoid battery exhaustion
Keep the vehicle engine running when using
this unit to avoid draining the battery power.
WARNING
Do not use with vehicles that do not feature an
ACC position.
<127075004506>3
En 3
English
Section
01
Precautions

Black plate (4,1)
About this unit
This unit is a TV tuner for the Pioneer DVD
RDS AV Receiver.
Important
!Please note that this unit is not compatible
with Pioneer DVD RDS AV Receiver models
sold before September 2012.
!For a list of models that are compatible with
this unit, refer to the information on our web-
site.
CAUTION
!Do not allow this unit to come into contact
with liquids. Electrical shock could result.
Also, damage to this unit, smoke, and over-
heating could result from contact with liquids.
!Keep this manual handy for future reference.
!Always keep the volume low enough to hear
outside sounds.
!Avoid exposure to moisture.
!If the battery is disconnected or discharged,
any preset memory will be erased.
!Should this unit fail to work properly, please
contact your dealer or nearest authorized
PIONEER Service Station.
About this manual
This unit features a number of sophisticated
functions to ensure superior reception and op-
eration. All the functions have been designed
for the easiest possible use, but many are not
self-explanatory. This operation manual will
help you benefit fully from this unit’s potential
and to maximize your listening enjoyment.
Note
Refer to the Pioneer head unit owner’s manual
for operating instructions for the Pioneer head
unit.
Resetting the microprocessor
Pressing RESET lets you reset the micropro-
cessor to its initial settings.
The microprocessor must be reset in the fol-
lowing situations:
!Before using this unit for the first time after
installation
!If the unit fails to operate properly
!When strange or incorrect messages ap-
pear on the display
%Press RESET with a pen tip or other
pointed instrument.
RESET button
<127075004506>4
En
4
Section
02 Before you start

Black plate (5,1)
Important
!This unit can not be installed in a vehicle that
does not have an ACC (accessory) position on
the ignition switch.
O
N
S
T
A
R
T
O
F
F
ACC position No ACC position
!Use of this unit in conditions other than the
following could result in fire or malfunction.
—Vehicles with a 12-volt battery and negative
grounding.
!To prevent a short-circuit, overheating or mal-
function, be sure to follow the directions
below.
—Disconnect the negative terminal of the
battery before installation.
—Secure the wiring with cable clamps or ad-
hesive tape. Wrap adhesive tape around
wiring that comes into contact with metal
parts to protect the wiring.
—Place all cables away from moving parts,
such as the shift lever and seat rails.
—Place all cables away from hot places,
such as near the heater outlet.
—Do not connect the yellow cable to the bat-
tery by passing it through the hole to the
engine compartment.
—Cover any disconnected cable connectors
with insulating tape.
—Do not shorten any cables.
—Never cut the insulation of the power cable
of this unit in order to share the power
with other devices. The current capacity of
the cable is limited.
—Use a fuse of the rating prescribed.
Notes
!Check all connections and systems before
final installation.
!Do not use unauthorized parts as this may
cause malfunctions.
!Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.
!Install the unit where it will not get in the dri-
ver’s way and will not injure passengers if
there is a sudden stop.
!When mounting this unit, make sure none of
the leads are trapped between this unit and
the surrounding metalwork or fittings.
!Do not mount this unit near heater outlets
where it would be affected by heat, or near the
doors where rainwater might splash onto it.
!Before drilling any mounting holes, always
check behind where you want to drill the
holes. Do not drill into the gas line, brake line,
electrical wiring or other important parts.
!If this unit is installed in the passenger com-
partment, anchor it securely so it does not
break free while the vehicle is moving, caus-
ing injury or an accident.
!If this unit is installed under the front seat,
make sure it does not obstruct seat move-
ment. Route all leads and cords carefully
around the sliding mechanism so they do are
not caught or pinched in the mechanism and
cause a short-circuit.
<127075004506>5
En 5
English
Section
03
Connections