Planet NOVASwitch Series User manual

0
10/100Mbps Switch
FNSW-800
Modules
FNSW-001ST / FNSW-001SC
Quick Installation Guide

1
FCC Warning
These devices have been tested and found to comply with
the limits for a class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interface when the equipment is
operated in a commercial environment. This equipment
generates, uses an can radiate radio frequency energy and, if
not installed and used properly may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct
the interference at the user’s own expense.
Revision
This installation guide is used for PLANET NOVASwitch
series-
Model: FNSW-001ST, FNSW-001SC
Revision: 1.0 (October, 1998)
Part No.: EMQ-FNSW001
Copyright © 1998 Planet Technology Corp.
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology
Corp. The information in this manual is subject to change
without notice. All other trademarks belong to their respective
owners.

2
Part One: Outlooks, Check List & Features
Outlooks
Extension module for FNSW-800
FDXHDX
FDXHDX
ST /SC Interface
FNSW-001ST/FNSW-001SC:
1-port 100Base-FX switch extension module
Check List
Modules:
♦The Module
♦This Installation Guide

3
Part Two: Installation
Installation
1. Cabling Guidelines
♦Maximum length of a multi-mode fiber cable (62.5/
125µm) is:
2 kilometers (6560 feet) for full-duplex, or
412 meters (1351 feet) for half-duplex 100Base-FX
after module installed
2. Power off the FNSW-800 and remove the unit from the 19-
inch rack.
3. Release the two screws to remove the module cover. Make
sure the last port (port#8) is free
4. Slide in the module follows the chutes firmly. Secure the two
screws.
Extension Slot
Full-Duplex
Half-Duplex
5. Put back the switch.
6. Make the connection follow the cabling guidelines above.
Note, please check the mode (Full/Half-Duplex) of the
device that is going to attached to and set the DIP switch.
7. Power on the unit and the connected devices, the LED
indicators of port#8 will blink follow the user's guide of
FNSW-800, section "LED Indications".