Plasma Air PlasmaPURE AutoClean 1500 Instruction manual

www.plasma-air.com/residential
INSTALLATION, OPERATION
& MAINTENANCE MANUAL
PlasmaPURE
AutoClean 1500
04/2020

SELF-CLEANING & NO MAINTENANCE
The PlasmaPURE AutoClean 1500 is a self-cleaning, maintenance-free
needlepoint ionizer that produces positive and negative ions that neutralize
harmful pollutants and odors in the home. This compact self-cleaning unit
automatically removes dust and dirt build-up on the needles eliminating the
need for maintenance. It can be easily mounted at the fan inlet of almost any
air handling system including residential air conditioners, furnaces, mini-splits,
fan coil units and VRF systems. The AutoClean 1500 is self-contained in a
plastic enclosure which has molded tabs with mounting slots. Unit accepts
12V DC or 24V AC without the use of an external power supply.
MECHANICAL INSTALLATION INSTRUCTIONS
GENERAL MOUNTING CRITERIA:
1. Do not connect to power before mechanical installation is complete.
2. Mount ionization unit to allow for future access.
3. Mount the unit at or near the fan inlet using the slots in the mounting tabs,
insuring that air flows over the two recessed needlepoint electrodes
simultaneously. Short sheet metal screws should be used to mount the
ionizer to the fan casing. See Figures 1 & 2.
4. The unit should be mounted downstream of the filter.
5. For best results avoid locations directly downstream of a cooling coil or
humidifier.
FIGURE 1
AIR FLOW
RECESSED NEEDLEPOINT ELECTRODES
FIGURE 2
FAN
DISCHARGE
FAN INLET
CONNECTTO GROUND
WHERE NECESSARY
CONNECT
TO POWER
12V DC or
24V AC
MOUNTING TABS
RECESSED NEEDLEPOINT
ELECTRODES

ELECTRICAL INSTALLATION INSTRUCTIONS
WARNING: Do not connect to power before installation is complete.
Always disconnect power to the unit before handling the ionizer.
1. All field wiring to be in accordance with the National Electric Code and
authorities having jurisdiction.
2. Connect power to ionizer using either 12V DC or 24V AC. See Figure 3.
3. Connect power wires to power inlet fitting by pressing the orange tab
firmly, inserting the appropriate wire, then releasing the orange tab.
Repeat as necessary for the other wires. Strip wire insulation as
necessary.
4. For best results interlock ionizer power with fan relay.
5. Apply power to the unit. The LED indicator will be green when power is
applied to the ionizer, but then turns orange when functioning properly.
OPERATION
1. When power is applied to the unit, the ionizer will be activated. The LED
indicator will change from green to orange to indicate proper operation.
2. The ionization unit is self balancing and does not require any type of
adjustment.
3. Self-cleaning frequency is factory set at once per day. To change this
frequency, contact Plasma Air for factory programming. During the short
self-cleaning process, the LED indicator will temporarily turn green.
TROUBLESHOOTING
If the unit is not operating, check the following:
1. Verify that all power connections are correct and tight. Reconnect any
loose wires as necessary.
2. The supply fan is running during operation, and that the orange LED
illuminates. If the LED is green, and cleaning cycle is not active (wait a few
minutes), contact Plasma Air for further support.
CONNECT
TO POWER
12V DC or
24V AC
BLACK AC/RED DC
POWER INLET FITTING
PRESS ORANGE TABS
TO INSERT WIRES
WHITE AC/BLACK DC
FIGURE 3

PA-RES-US-IOM-009-REV1
©2020 All rights reserved.
www.plasma-air.com/residential
PLASMA AIR
35 MELROSE PLACE
STAMFORD, CT 06902
phone [phone]
fax [phone]
[e-mail]