Playskool Playskool Busy Ball Drop User manual

Thank you for choosing this
PLAYSKOOL toy!
x2
BATTERIES INCLUDED
1.5V AA or R6 size
Replace with 2 x 1.5V “AA” or R6 size batteries.
Alkaline batteries recommended. Phillips/cross
head screwdriver (not included) needed to
replace batteries.
busy
basics
™
Busy Ball
Drop™
09946
ages &
stages®
months
6
OVER
to play

With the BUSY BALL DROP toy, your child will
learn about cause and effect and enjoy a musical
surprise!
Have your child put
all three balls on top
of the tree. Make
sure one ball is in
center position of the
treetop. When she
pushes straight down
on the ball it will pop
down the hole, trigger
jungle music and
sounds. The ball will
spiral down the tree
trunk and roll out the
bottom away from the
child encouraging her
to crawl after it.
ages &
stages®
months
6
OVER
to play

IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be
sure to insert them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
battery. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old batteries and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
to replace
batteries
Use a Phillips/cross
head screwdriver (not
included) to loosen
screw in battery
compartment door
(screw remains attached
to door). Remove door.
Remove old batteries.
Insert 2 “AA” or R6 size
batteries. Alkaline
batteries recommended.
Replace door and
tighten screw.

Questions? Call 1-800-PLAYSKL
7HRHS
7HRHS
 BNL  BNL
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
© 2007 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
09946 PN 6738910000