Playskool Speedstars Vortex Speedway 06712 User manual

Includes 1 car body
(#036), 1 chassis, 1
power winder, 1 car
token, 1 track piece,
1base, 2 top sections,
2middle sections,
2top connectors,
2middle connectors,
1door and 1 label sheet.
CAUTION:
Hair entanglement may result if child’s hair
comes in contact with moving parts of toy.
Adult supervision is required.
™
Vortex
Speedway™
Vortex
Speedway™
Thank you for choosing this awesome SPEEDSTARS playset!
AGES 3+
06712
Adult assembly required.

ASSEMBLY
1. Fit middle sections together. 2. Snap 2 middle connectors onto
middle sections as shown.
3. Place door in base, fitting lower
pin on door into hole in base. 4. Snap middle section assembly
onto base, fitting upper pin on
door into hole in middle section.
5. Fit 2 top sections together. Fit top
connectors onto top sections.
(Tabs on connectors fit into holes
in top sections; forks on connectors
fit into slots in top sections.)
6. Snap top section assembly
onto middle section assembly.
7. Fit lip on track piece into top
slot on base ramp. 8. Peel and apply labels to the
outside of track as shown.
MMIIDDDDLLEESSEECCTTIIOONNSS
TTRRAACCKKPPIIEECCEE
MMIIDDDDLLEECCOONNNNEECCTTOORRSS
LLOOWWEERR
PPIINNBBAASSEE
TTOOPP
SSEECCTTIIOONNSS
TTOOPP
CCOONNNNEECCTTOORRSS
UUPPPPEERRPPIINN
KKEEYY
DDOOOORR
RRAAMMPP
11
22
33
44

•For glow-in-the-dark racing
action: Hold the car up to a
light for 15-30 seconds. Then,
in a dark room, place it on
the track and watch it go –
and glow!
PLAY FEATURES
•Snap the car
body onto the
chassis. Place
the car onto
the power
winder, hold
the car in place
and crank the
handle until the car is fully
wound (approximately 10-15
times). Place the car on
the track, press the button
and watch it zoom around
the speedway!
Note: For best performance,
be sure the track piece
is straight.
Enjoy super-fast ‘round ‘n ‘round racing fun with this
awesome circular speedway!
•All SPEEDSTARS parts are
completely interchangeable. For
extra excitement, connect the
track piece to the EXTREME
LOOP™ Track (not included).
•Push in latch on front of chassis
to remove car body from chassis.
LLAATTCCHH

•Remove track piece from ramp and slide it (on its side) into base until fully
inserted.
•Store the power winder on side of base (posts on base into holes in
power winder).
•Store the car in center of base.
© 2003 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
06712 P/N 6305980000
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-PLAYSKL
STORAGE