Playskool Swing 'n Score Baseball 06195 User manual

OVER 9 months
06195
Thank you for choosing this PLAYSKOOL brand product!
Includes 3 x 1.5V “AA”/R6 batteries. Alkaline
batteries recommended. Phillips/cross head
screwdriver (not included) required for battery
installation.
Includes base, post (with arm and baseball attached),
and bat.
Adult assembly required.
Swing ‘n Score™
Baseball
Swing ‘n Score™
Baseball

ASSEMBLY
Insert post into base
(listen for snap).
PLAY FEATURES
Batter up! The SWING ‘N SCORE Baseball toy “comes alive” with the
sounds of the game every time your child bats the ball or presses
home plate!
•As your toddler grows, you can adjust the height of the post. Lift
dome and turn clockwise to raise the post. (Lift arm and turn
counterclockwise to return to lower position.)
GGrroowwsswwiitthhyyoouurrbbaabbyy!!
LLiiffttaannddttuurrnnttooaaddjjuusstthheeiigghhtt
PPOOSSTT
BBAASSEE
CChhuunnkkyy,,eeaassyy--ggrraassppbbaatt!!
SSttoorreebbaattoonn
bbaasseebbaallllaarrmm!!
HHiitttthheebbaalllloorr
pprreesssshhoommeeppllaatteettoo
ssttaarrtttthheeaaccttiioonn!!
HHeeaarrtthheeccrraacckkooff
tthheebbaattaannddtthheerrooaarroofftthhee
ccrroowwddaasstthheeaannnnoouunncceerr
ccaallllsstthheeaaccttiioonn!!
SSiinnggaalloonnggttootthhee
mmuussiiccooff““TTaakkeeMMeeOOuuttttoo
tthheeBBaallllggaammee””!!
SSttaarrlliigghhttssuuppwwhheenn
yyoouuhhiitttthheebbaallll!!
NNuummbbeerrss
lliigghhttuuppaanndd
ttwwiinnkkllee!!
Note: To prevent accidental
activation, slide the switch on
bottom of toy to “OFF.”
PPllaayybbaallll!!
GGooiinngg,,ggooiinngg
ggoonnee!!

TO REPLACE BATTERIES
Use a Phillips/cross head
screwdriver to loosen screw
in battery compartment door
(screw remains attached
to door). Remove old
batteries. Insert 3 fresh
"AA”/LR6 (1.5V) alkaline
batteries. Replace door and
tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1) Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers' instructions;
2) Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3) Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and
be sure to insert them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
battery. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.

© 2003 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
06195 P/N 6286610000
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-PLAYSKL
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.