Plinth 2000 BARI3 User manual

Bariatric Trolley
Model: BARI3
SERVICE MANUAL

Bariatric Trolley Service Manual
2 | P a g e
Contents
1. Introduction 3
General Warnings 3
2. Cleaning and Decontamination 4
3. Maintenance 5
General Maintenance 5
Service Checklist 6
4. Troubleshooting 7
5. Parts List and Diagrams 8
Exploded Diagram 9
Base Drawing 10
Lift Lever Drawing 11
Link Lever Drawing 12
Middle Drawing 13
Top Drawing 14
Back-Rest Drawing 15
Leg-Rest Drawing 16
Foot Board Drawing 17
Cot Side Rail Drawing 18
Arm/Side Support Drawing 19
6. Guarantee and Service 20
7. Technical Specification 21
8. Revisions to Manual 22
Plinth 2000 Ltd is an ISO Audited company to ISO9001:2008

Bariatric Trolley Service Manual
3 | P a g e
Our products are CE marked in conformity with the EC Directive MDD 93/42/EEC
1. Introduction
Thank you for purchasing a product from Plinth 2000 Ltd. We use the highest quality
components and manufacturing techniques to ensure that our products are simple
to use and will last a long time. It is recommended that all users read and retain this
User Manual for reference.
Throughout this manual notice is made of a Warning and Caution system to highlight
to the user practices, procedures or conditions that should either not be allowed to
happen or happen with caution.
Warnings are in a box with bold type and identify potential hazards, procedures or
conditions which could result in death, injury or serious damage.
Cautions are in a box with plain type and identify conditions or procedures where if
caution is not taken it may result in damage or failure of equipment.
General Warnings
WARNING
Maximum Load (SWL) is 320kg distributed evenly.
Do not use flammable gasses in proximity to an electrically operated trolley.
Do not concentrate weight on either side or either end of the trolley.
Use only accessories approved for use with this trolley.
Children must be adequately supervised in the presence of the trolley.
Do not allow children to play with the trolley at any time.

Bariatric Trolley Service Manual
4 | P a g e
2. Cleaning and Decontamination
WARNING
If contamination is suspected then decontaminate the trolley before use.
Torn or damaged upholstery should be replaced immediately.
CAUTION
Do not use Alkalis or other organic solvents for routine cleaning.
Always cover the vinyl with paper towelling or trolley covers if it can come into
contact with bare skin.
Cleaning
Always wear suitable protective clothing before carrying out this procedure.
Disconnect the mains supply to the trolley and move it to a suitable cleaning area
and lock the castors.
Step 1. Using warm water and soap on a damp cloth, carefully wipe the trolley over
from top to bottom. Take great care around electrical components.
Step 2. Wipe the trolley carefully from top to bottom using a clean damp cloth and
soap free water.
Step 3. Carefully dry the trolley from top to bottom with clean lint free paper towels.
Decontamination
To decontaminate the trolley repeat the above steps but using a dilute solution of
Hypochlorite and warm water (10,000ppm) instead of warm water and soap. At the
end of the procedure discard all cleaning materials in a safe manner and wash hands
thoroughly.

Bariatric Trolley Service Manual
5 | P a g e
3. Maintenance
Plinth 2000 Ltd products are designed to be maintenance free. However keeping
your Plinth products clean and regularly checked will assist in prolonging their
working life. The following is a guide of simple checks that the user can carry out on
a six monthly basis. We would also recommend an annual service visit by a Plinth
2000 trained engineer.
WARNING
Disconnect trolley from electrical supply before commencing any of the following
checks.
Examine the trolley for any signs of damage. Pay particular attention to all nuts, bolts
and fasteners to check they are present and tight but not over tight.
Upholstery bolts should all be checked (each section has between 2 and 6 No. M6
bolts), they should all be present and tight.
Check gas struts (if fitted) and ensure that they operate through the full range of
movement and lock fully.
Check hinge pins are lubricated and not rusty.
Check main trolley nylon pivot bearings are lubricated sufficiently.
Examine mains and switch cables for any damage, cuts, kinks, abrasions etc. These
must be replaced if necessary.
Check mains lead, switch cables and slave motor leads are all correctly and securely
attached.
Check correct plug fuse is fitted (5A).
WARNING
Any electrical checks or work other than the visual inspection above must be
performed by a qualified electrician.
Do not connect BLUE or BROWN wires to the earth terminal of a plug.

Bariatric Trolley Service Manual
6 | P a g e

Bariatric Trolley Service Manual
7 | P a g e
4. Troubleshooting
In the unlikely event of the trolley failing to operate and having carried out the
normal practical fault finding steps below then please contact our Customer Service
Team on [phone] or email [email protected]. Please
have the serial number to hand before making contact so we can help you more
efficiently.
Fault
Possible Cause
Remedy
Trolley is unstable
Uneven floor
Damaged Castor
Move trolley to flat floor
Check presence and
condition of all castors
All motors will not work
Power disconnected
Hand/ Footswitch
disconnected
Connect power supply
Check the switch is fully
connected to the motor
One motor will not
work but other is
working
Lead from height
motor/control box not
connected to slave motor
Fault with switch
Fault with control box
Fault with motor
Check and connect all leads
Replace switch
Replace control box
Replace motor
Motor sinks
Switch permanently
operated
Motor fault
Unplug and re-connect
switch
Replace motor
Backrest will not work
See one motor will not work
section above
See one motor will not work
section above
Leg rest sinks under
load
Gas spring adjustment
Gas spring fault
Adjust Gas spring
Replace Gas spring
Armrests slip or are
loose
Locking thumbwheels not
correctly tightened
Thumbwheels damaged from
over tightening
Correctly tighten locking
thumbwheels
Replace thumbwheels

Bariatric Trolley Service Manual
8 | P a g e
5. Parts List and Diagrams

Bariatric Trolley Service Manual
9 | P a g e

Bariatric Trolley Service Manual
10 | P a g e

Bariatric Trolley Service Manual
11 | P a g e

Bariatric Trolley Service Manual
12 | P a g e

Bariatric Trolley Service Manual
13 | P a g e

Bariatric Trolley Service Manual
14 | P a g e

Bariatric Trolley Service Manual
15 | P a g e

Bariatric Trolley Service Manual
16 | P a g e

Bariatric Trolley Service Manual
17 | P a g e

Bariatric Trolley Service Manual
18 | P a g e

Bariatric Trolley Service Manual
19 | P a g e

Bariatric Trolley Service Manual
20 | P a g e
6. Guarantee and Service (UK only)
Plinth 2000 Ltd offer a 5 year parts guarantee on all Premium Range products
delivered from January 2013 and a lifetime frame guarantee. The only exclusion to
this guarantee is for negligent damage or damage to upholstery coverings. This
guarantee does not require registration of the product as we can trace it from its
serial number, however in the event of the serial number being removed, missing or
unreadable then this may void the guarantee. These terms do not affect your
statutory rights.
In addition to the above Plinth 2000 Ltd can offer both extended warranties and
service contracts. For further information about either of these please contact:
Customer Service
Plinth 2000 Ltd
Wetheringsett Manor
Wetheringsett
Stowmarket
Suffolk
IP14 5PP
Tel: [phone]
Mail: [email protected]
In the event of returning a product or part to us then please follow the instructions
for cleaning under section 5 before enclosing it in suitable packaging and returning it
to the above address. In addition please ensure there is a statement confirming that
it has been decontaminated and what the fault is along with relevant contact details.
Worldwide
Please contact the distributor you purchased the trolley from for service and support
in your country. If you are unable to do so then please contact us in the UK and we
will refer you to our local representative.