Plymold Z000000373 User manual
1
615 Centennial Drive Kenyon, MN 55946
Phone 507-789-5111, 800-PLYMOLD (759-6653)
Email: subwaysupport@plymold.com www.plymold.com
INSTALLATION INSTRUCTION
COMPONENT INDEX FOR ASSEMBLY
UNPACKING YOUR SHIPMENT
Unpack and identify each component in each box that you received. If your shipment is missing parts,
or too many parts were shipped, please contact Plymold.
TOOLS REQUIRED
7/16” WRENCH
ATTENTION INSTALLERS: PLEASE PRESENT INSTALLATION DOCUMENTS TO FACILITIES MANAGER.
(4) 1/4”-20 UNC Nut
(1) Button Seat
DATE: 8-15-12
PRODUCT: BUTTON SEAT ATTACHMENT
MANUAL: Z000000373
Base Sold
Separately
2
INSTALLATION MANUAL
STEP 1: ATTACHING BUTTON SEAT TO POST
1. Align the studs on the bases of the swivel to the holes on the seat post.
2. Place 1/4”-20 nut over each stud and firmly tighten with 7/16” wrench.
3. Clean furniture and protect unit until ready for use.
CARE & MAINTENANCE
Periodic maintenance is necessary to ensure long term durability and customer satisfaction. Buyers must therefore advise end user of
the following:
To prevent personal injury, furniture must be inspected regularly for loose screws, glides and casters, cracked or broken welds,
cracked laminate, wood splinters and general instability . Furniture that is damaged or appears to be unstable must be immediately
removed from service and replaced or repaired using only factory authorized parts and methods. Contact Plymold Customer Service
for assistance and further instructions.
PAINTED METAL CARE:Wipe with a damp cloth. For stubborn stains and grease, use a mild soap and water.
WARRANTY AGREEMENT:
Plymold/Foldcraft Co. warrants all products manufactured and/or marketed by Plymold/Foldcraft Co. to be free from defects in material
and workmanship under normal usage and service for one (1) year from date of purchase shown on our commercial invoice. Warranty
on upholstery materials is governed solely by the guarantee or warranty of the producing mill. Warranty on wood table tops may be
affected by moisture conditions and usage. Solid wood table tops must be stored and used in environments with relative humidity in
the range of 35% to 50%. Customer assumes responsibility for normal wear and tear. This agreement excludes all products or
component parts, that in the opinion of Plymold/Foldcraft Co., have been subject to neglect, misuse, alteration, accidental or improper
installation. Some products may have extended warranties.
7 years: Metal Mesh - PVC topcoat against chipping, peeling, and cracking
5 years: Metal Stool and Chair Frames Metal Frames
Dur-A-Edge® Tops & Side Panels Contour Seats
1 Year: All Other Products
Table of contents
Other Plymold Indoor Furnishing manuals
