PMD Personal Microderm Device User manual

INSTRUCTION MANUAL
REV 6/2015

Warning
Failure to use this product strictly in accordance with
the wrien instrucons and the instruconal video,
including removal of the plasc safety guard during
any use of the product, could result in injury to your
skin, including scabbing.
Do not use this product without first viewing the
instruconal video and following the instrucons
and adhering to the safety warnings explicitly. Do not
operate this product without the safety cap in place
at all mes.

3
WARNINGS
1.
2.
3.
4.
5.
6.
This PMD Personal Microderm is not intended for persons
with reduced physical, sensory or mental capacies unless
supervised by a responsible party.
Users 18 and under must be supervised by an adult.
For indoor use only.
Keep the PMD Personal Microderm dry.
If the power cord or adaptor is damaged it must be replaced
by the manufacturer.
Only use parts or adaptors supplied in package.
Unplug from outlets when finished and when cleaning.

4
INTRODUCTION
The Personal Microderm is a
revoluonary at-home skincare
tool that provides the same
brilliant results as professional,
in-office microdermabrasion
treatments.
By combining the power of
Patented Spinning Disc
Technology and Perfectly
Calibrated Vacuum Sucon, the Personal Microderm works to
remove the dead, dull skin cell barrier, increase blood flow, and
smulate the body’s natural producon of collagen and elasn.

5
GETTING STARTED
Watch the DVD
A DVD has been included with your Personal Microderm.
It contains important informaon and demonstraons to
prepare you in geng the most out of your Personal Microderm
treatments.
Please watch before
you use the product
INSTRUCTIONAL DVD
getpmd.com

6
PREPARING FOR TREATMENT
Thoroughly cleanse the skin. Make sure it is free from all makeup,
dirt and oils. We recommend using the PMD Advanced Soothing
Cleanser, since it is specifically formulated to work with the PMD
device and treatments.
Once the skin is clean, allow it to dry completely before you begin.
A dry skin surface is parcularly important because it allows the
PMD to work properly and effecvely. If the skin is damp or
clammy, the disc will be unable to smoothly glide over it.

7
1 2
CONNECTING THE POWER CORD
Step 1: Connect the power cord to the device.
Step 2: Turn the connector one quarter turn unl it locks in place.
Note: There is no baery for this device. It is designed to run off a
power cord to maintain consistent performance.

8
IMPORTANT: The White disc is for training, use the Grey disc for the first treatment.
Small Disc
For face and delicate areas
Large Disc
For body use and larger surfaces
CHOOSING A DISC
Always begin the first treatment with the white training disc. Start
on the hand or neck before moving to the face. This will help you
pracce before using a stronger disc.
Aer praccing with the white disc, move to the grey disc, which is
the most gentle. Use the small disc for the face and delicate areas
and the large disc for the body.

9
White Disc
For ultra sensive skin
Gray Disc
For very sensive skin
Blue Disc
For sensive skin
Green Disc
Medium strength abrasion
Red Disc
Maximum strength abrasion
Black Disc
For use only on the body
DISC OPTIONS

10
INSERTING THE DISC
STEP 1
Push the disc down firmly on the post.
STEP 2
Twist on cap. Be sure to ghten
the cap firmly against the black O-ring.
STEP 3
Make sure the disc is sing slightly
below the cap. Adjust if necessary.