PMD PRO User manual

INSTRUCTION
MANUAL

PMD Personal Microderm Device
Manual Contents
Warnings
Introduction
Getting Started
Preparing for Treatment
Choosing a Disc
How to Use the Device
Cleaning & Maintenance
PMD Do’s and Don’ts
Please read and follow all of the instructions
enclosed, failure to do so could result in injury.

1. This appliance is not intended for use by persons (including
children) with reduced physical, sensory, or mental capacies,
or lack of experience and knowledge, unless they have
been given supervision or instrucon concerning use of the
appliance by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play
with the appliance.
3. This appliance is for indoor use only.
4. Keep the appliance dry.
5. If the detachable plug blade of adaptor or power cord was
damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
6. Only use adaptors or parts supplied on package.
7. Always unplug from mains when cleaning.
Warnings

Introducon
Whether microdermabrasion is performed in a professional
seng or in your own home with a do-it-yourself microderm
device, the principle behind the treatment is the same.
The idea behind microdermabrasion is that if you break- apart
and remove the dead skin cells on the stratum corneum skin layer,
the body will interpret this as a mild injury and rush to replace the
lost cells with healthy new ones.
This process benets the skin in numerous ways. When the
stratum corneum is removed, the skin’s surface, tone, and texture
are visibly improved. The new cells generated during the healing
process look and feel smoother.
Without the stratum corneum acng as a barrier, skin care
products can be fully absorbed and this increased penetraon
helps maximize product benets. Skin care products are up to 20
mes more eecve when combined with microdermabrasion.

Thoroughly cleanse your skin.
Make sure that it is free from
all make up, dirt, and oils. It is
recommended using the PMD
Soothing Anoxidant Cleanser,
specically formulated to work
with the PMD device.
Once the skin is clean, let it
completely dry before beginning
the treatment. A fully dried
surface is extremely important
because it allows the Personal
Microderm to work properly and
eecvely. If the skin is damp
or clammy, the disc won’t glide
smoothly over the surface.
Preparing for Treatment
Skincare

1 2
Step 1: Connect the power cord to the device.
Step 2: Turn the connector one quarter turn unl it locks in place.
Please note that there is no baery for this unit. It is designed
to run o of a power cord in order to maintain consistent
performance.
Connecng the Power Cord

Choosing a Disc
Begin treatment on the hand or behind the neck before using
a higher exfoliang disc. This disc was developed to help you
pracce and feel comfortable with the device, along with seeing
how your skin will react.
Aer praccing with the white disc, move on to the gray disc,
which is the most gentle. Using the small disc for face and delicate
areas and the large disc on your body.
IMPORTANT: The White Disc is for Training. Use Gray Disc for your first treatment.
Small Disc
For face and delicate areas
Large Disc
For body use and larger surfaces

Choosing a Disc
Disc Opons
White Disc
For ultra sensive skin
Gray Disc
For very sensive skin
Blue Disc
For sensive skin
Green Disc
For normal to non-sensive skin
Red Disc
For normal to very course skin

Choosing a Disc
Inserng the Disc
2
3
1
Step 1: Push disc down rmly
on device post.
Step 2: Twist cap on. Make
sure that cap is secured ghtly
against black o-ring.
Step 3: Disc must sit slightly
below plasc cap. Adjust if
necessary.

How To
1. Cleanse and dry skin thoroughly
2. Using the white disc, pracce on arm or leg before using on face
3. Pull skin ght to help device to smoothly glide over skin
4. Move the device across skin in an upward moon
NOTE: Do not make more than 2 passes over one area during
treatment
5. Following treatment apply toner and moisturizer
6. Wash the cap and lter aer each use
7. Wait 6-7 days between treatments.

Cleaning & Maintenance
Dissasembling the Device
2
3
1
Step 1: Remove cap by twisng
counter-clockwise.
Step 2: Pull disc straight o.
Step 3: Pull out dark lter.

Cleaning & Maintenance
Cleaning the Device
Step 1: Clean cap with rubbing alcohol or an anbacterial soap.
Step 2: Clean lter with warm water and rubbing it between
ngers and thumb.
Step 3: Once completely dry, place lter back in the device. If it is
not completely dry, vacuum will not work. (Do not put black lter
in wet).
IMPORTANT NOTE
For best results, replace the discs every 2 to 4 treatments,
since the aluminum oxide crystals that provide the exfoliaon
for your skin will wear o. The length of each treatment will
determine how long each disc will maintain its grit.

Do’s & Don’ts List
• Read direcons before your rst treatment
• Wash your skin so that it is totally free from all makeup, oils,
loon, and dirt.
• Make sure skin is completely dry before treatment.
• Pull skin taut with your free hand so that the PMD will
smoothly glide over skin.
• Start with the white training disc and then move to grey or
blue disc depending on skin type.
• Test product below the ear or on your leg to see how your
specic skin type will react to dic. Wait 3 to 4 minutes to see
if there are any adverse reacons.
• Use small disc and cap for face and large disc and cap for
body.
• Make sure disc sits below the cap. You can push disc down
aer cap is on.
Do’s
Remember: Everyone has dierent skin. Test is best.

• Don’t use any facial peel products like Alpha and Beta Hydroxy acid
or rena A or renol products 48 hours before or aer using the
PMD. Your skin will be too sensive.
• Don’t use if you are on Accutane.
• Don’t use if you are seeing a doctor for skin issues, have very
sensive skin, or are taking prescripons for your skin without your
doctor’s consent.
• Don’t use directly above or below your eyes.
• Don’t hover in one spot. You will quickly learn how your skin reacts
to the treatment. Use your best judgment to gauge the intensity
with which you use the PMD.
• Don’t keep going over the same spot mulple mes. What the
PMD is doing is not always visible immediately. Be paent and aer
2 to 3 uses you will learn how to best apply treatments on your
unique skin.
• Don’t connue the treatment if you feel pain. Pain will occur if you
have gone too deep. You will feel ngling and disnct sensaon but
it should not be painful. Gauge this on your skin type.
• Wait 6-7 days before next treatment so skin can rejuvenate.
• Clean the cap and lter aer use, with rubbing alcohol or
anbacterial soap and let dry.
Don’ts

If you follow these instrucons closely, we are confident that
you will love the results you receive from your PMD Personal
Microderm treatments. We also welcome your comments,
quesons, and feedback. You are now ready to use your PMD
Personal Microderm and begin to uncover younger skin.
- PMD Team
#brilliantconfidence