Pocketbook Obreey A 10 Use and care manual

Firmware Update Manual
MODEL: POCKETBOOK A 10
You can update rmware in several ways.
ATTENTION! Please, make sure the Device is fully charged before updating the rmware to avoid discharge during update process! This may cause
severe damage of the Device’s software.
AUTOMATIC UPDATE
Your Device should be connected to the Internet for this update variant.
1. Enter Settings > About device > System updates section
2. If you’d like the Device to check for updates automatically, check Enable or disable autoupdate
checkbox
3. To check for updates immediately, press Check now new rmware.
If rmware updates are available, the Device will automatically download and install them.
MANUAL UPDATE
Variant 1
1. Download to your PC rmware version you’d like to install
2. Connect your Device to PC and copy rmware le (.upkg extension) to the internal storage or ex-
ternal microSD-card
3. Go to Settings > About device > System updates section
4. Select SD card or External microSD card depending on the rmware le location
5. In the list appeared select the rmware version to install and press OK.

Variant 2
1. Download to your PC rmware version you’d like to install
2. Connect your Device to PC and copy rmware le (.upkg extension) to an external microSD-card
ATTENTION! In this variant you can install rmware from external card only!
3. If the Device is on, turn it off by continuous power button press and selecting the corresponding
choice in switch off menu
4. Press and hold Volume + button and switch the Device on by pressing power button
5. Android system recovery menu will appear (Android logo with exclamation mark). Now you can
release Volume + button
6. Select apply update from sdcard using Forward/Backward hardware keys and press Menu key to
conrm choice
7. The Device will perform all the necessary update action and will reboot.
NOTE To exit Android system recovery, select reboot system now.