PodoMonium MiniMonium User manual

USER MANUAL
PODOMONIUM® MINIMONIUM
Issue : 22-12-2017
EN

INFORMATION :
Podomonium Minimonium is a standard manicure
drill for nail salon use .
The size of the machine is very small and light
weight , convenient to use .
The speed is 0-30,000rpm adjustable. and the
direction of the drill can be switch left & right
turning.
*1 year full warranty except shipping cost for parts .
SPECIFICATION : 230V ~ 50Hz
65 WATT

DISPLAY & INDICATION
1
2
3
4
5
6
7
8 9
10
FRONT :
BACK :

1 : ON/OFF Power Switch
2 : Handpiece outlet socket
3: Rotary Speed - / Speed +
4: Drill direction switch
Left / Right *
5: Handpiece Holder
6: Handle
7 : Handpiece
8: Footpedal socket *
9: Fuse
10: Power cable
*
4:Drill direction switch Left/Right , when the switch is left , the
drill starts anti-clockwise rotation, when the switch is right ,
the drill starts clockwise rotation, when the switch is at the
MIDDLE position , the drill STOP rotation.
8:Footpedal socket , the footpedal is optional for purchase
according to the needs of the user.
ATTENTION :
Handpiece CANNOT be cleaned in the ultrasonic cleaner.
Handpiece can be wiped o!with alcohol 70%.
ADVICE ! DO NOT CLEAN THE HANDPIECE IN THE ULTRASONIC BATH.

WORKING WITH THE MACHINE
A. Connect the machine to an earthed wall socket or any valid
extension cord .
B. Connect the handpiece to the machine handpiece outlet socket.
C. Push the power switch ON .
C. Set with the aid of rotary knob , less speed by turning left .
D. Set with the aid of rotary knob, more speed by turning right .
CAUTION ! ROTATION DIRECTION MUST ALWAYS BE ADJUSTED
WHEN THE ENGINE IS SWITCHED OFF !
E. Work with the machine according to the normal method for
manicure motors if in doubt you can always seek advise from your
supplier .
IMPORTANT:
1. Use proper personal protection workwear like :
Wear safety glasses when working with diamond burs and
3-layer dust mask.
2. Work with a bou!ont cap to prevent long hair from hanging
loose.
3. Work in a proper posture,take plenty of breaks.
4. Work in a well lit area.
5. Do not work with large burs at high speed or with burs which
is out of balance .
6. After finishing the treatment switch o!the manicure motor
by pushing the switch to the OFF position.
7. At the end of the day the machine is Switched o!and unplug
the power cable