Point Source Audio CM-i3 Use and care manual

CM-i3 Intercom Headset
Earphone Replacement / Installation

1) Measure your desired cable “drop” from the ear hook, allowing enough
cable length for a taut but comfortable fit. 2) Align the earphone cable to the
ear hook groove to prepare for installation.

3) Use the “wide” side of the installation tool to insert the cable into the ear
hook groove. 4) Continue to install the cable along the ear hook through one
side of the headband. 5) Repeat for the second side. 6) Both left and right
cables should be installed and dressed down the center of the headband.

7) Attach your earphone connector to the female end of the earphone jack.

8) Gather both the microphone and earphone cables and insert into the
opening of the installation tool. 9) Insert the small end of the tool into the
cable wrap.

10) Push the top side of the installation tool through the cable using care to
hold the cables and the cable wrap together to avoid separation.

11) Slowly, continue to push the installation tool along the cable wrap until all
the cables are fully installed inside the cable wrap.