HINT: The display will show an icon "T" to
indicate TARE function is activated when the
total weight of all items on the scale is more
than 4% of the maximum weight capacity of the
scale. The capacity of the scale equals to the
maximum capacity of the total weight of the
items.
When using TARE function, you may check the
total weight of all items by pressing the ZERO
button. Then press the ZERO button again to
reset to zero and add another item onto the
scale to weigh.
If no movement is detected on the weighing surface for
2 minute and no button is pressed, the scale will
automatically switch o.
If the scale shows “Lo”, it indicates that the
batteries are too weak and it is time to replace the
batteries. Refer to the section "REPLACING
BATTERIES" to replace batteries.
If the scale shows “Err”, it indicates that the scale is
overloaded. The maximum capacity is indicated on
the scale. Step o the scale to avoid causing
damage to the scale.
AUTO SHUT OFF
ZERO / TARE function allows you to weigh dierent items consecutively with out
removing the items form the scale.
1. Place the first item you wish to weight onto the scale, the display will show the
weight of the first item.
2. Press the ZERO button to reset the display to zero. The "0" or "T" icon will appear
on the display.
3. Now add another item to weigh onto the scale. The display will show the weight
of the newly added item.
If you remove the item added to the scale, the display will again show zero. But if
you remove all items from the scale, the display will show a negative value
indicated by a minus sign.
4. Press the ZERO button again, and the "0" or "T" icon will disappear.
HINT: The display will show an icon "0" to indicate
ZERO function is activated when the total weight of
all items on the scale is less than or equal to 4% of
the maximum weight capacity of the scale. The
maximum capacity remains unchange.
“ZERO” OR “TARE” FUNCTION
WARNING INDICATORS
10 11
GB
