Polanik PVLID-S User manual

TECHNICAL SPECIFICATION / INSTRUCTION MANUAL
Stainless steel lid flush mount for pole vault box PVLID-S
I. Use
The lid is used to blank and protect the inside of the PV box during idle periods.

Technical specification / Instruction manual PVLID-S 2/4
II. Technical specification
Code
PVLID-S
Type
flush mount, designed for synthetic track surface 12 mm thick
Construction
stainless steel, ribbed
Net weight [kg]
21,5

Technical specification / Instruction manual PVLID-S 3/4
III. Installation
1. Place the lid in the box, make sure that the lid touches the shorter box edge (that one which is near the landing
area).
2. A piece of synthetic surface is to fill the space between the lid upper surface and the top of the runway. The lid is
designed for the synthetic surface which is approximately 12 mm thick.
synthetic surface
pole vault lid
pole vault box installed in runway
space to be filled by
synthetic surface
piece of synthetic
surface

Technical specification / Instruction manual PVLID-S 4/4
If a synthetic surface piece is to be sprayed or poured on the lid, please place thick foil in the box first, then put the lid
into the box and secure the wider edge with adhesive tape. Next install the surface and leave it to dry.
IV. Packing and transport
The product is packed in foil and transported on a pallet.
V. Maintenance
It is a maintenance free product.
PRODUCT SUPPORT: Pawel Ciechanowski [e-mail]
Even the best technical solutions cannot substitute for common sense. The usage of the product must take place
under the supervision of sports facility technical staff. The producer shall not be liable for any incidents caused by the
improper assembly or its misuse. The producer reserves the right to introduce without warning changes in product
constructions and colours.
File: 2016-12-20 © 2016 Polanik
synthetic surface
glued to the lid