16 17
Memory Set
Programming the Heart Rate Recording Intervals
In the measure mode, your receiver will always display your
current heart rate. But, depending on your needs, you can set it
to record the heart rate at intervals of 5, 15 or 60 seconds. A
longer interval will give you more recording time, but a shorter
interval will allow you to capture more heart data in a given
amount of time. The preprogrammed setting is 15 seconds.
Recording Interval Maximum Recording Time
5 sec 22h 10 min
15 sec 66h 32 min
60 sec 99h 59 min
You can save up to 99 separate files but the ultimate number will
be governed by the length of the file and the recording rate.
1. From the Time of Day display, press the upper right button two
times. The display will read, “OPTIONS.”
2. Press the red button once and the upper right button one
time. The display will read, “MEMORY SET.”
Note: In the lower right corner of the display you will see 5,
15, or 60. This is the number of seconds your receiver is
currently set at to record.
3. Press the red button one time. You will see “Rec. Rate”on the
upper line. The middle line will show the recording interval
(either 5,15 or 60) followed by “Sec”for seconds. The lower
line will show the amount of time left for recording.
4. On this screen, the only digits available for setting will be the
number of seconds on the middle row (which are now flashing).
You can adjust this value by using either of the right side
buttons. Notice that as you change the recording interval the
available memory, displayed on the bottom line, will shrink or
expand.
5. Lock in your choice by pressing the red button.
6. You can return to the Time of Day by pressing and holding the
blue button.
Watch Set
The Watch Set loop is accessed from the Options mode.
You can use it to set the correct time of day and date.
Programming the Time of Day
1. From Time of Day display, press the upper right button two
times. Your display will read, "OPTIONS".
2. Press the red button once and the upper right button twice.
Your screen will read, "WATCH SET".
3. Enter this mode by pressing the red button two times. "TIME"
will be displayed on the top row. The middle line will show the
default time of day and the number 12 or 24 will be flashing
on the lower line. Your HRM comes preset for the standard
U.S. 12 hour time clock. By pressing either button on the right
side you can switch it to a twenty four hour (i.e., military time)
clock. Whichever setting you select, press the red button one
time to lock in your selection. If you have picked the 12 hour
time clock, the am (or pm) will begin to flash.
4. By pressing either button on the right side, you can pick
whichever is appropriate.
5. Press the red button once to lock in your choice and the
hours will begin to flash.
6. Using either button on the right will alter the value of this
number. Lock in your choice by pressing the red button.
The minutes will begin to flash.
7. Using either button on the right will alter the value of this
number. Lock in your choice by pressing the red button.
8. Now you can return to the Time of Day by holding down the
blue button, or you can press the upper right button once to
set Timer 2. This timer is set in exactly the same way as Timer 1.
When you have set Timer 2, press and hold the blue button to
return to the Time of Day.
Note: If Timer 1 is set to OFF, Timer 2 will not be displayed.
E600 USA C manual.pm6 19.11.2002, 15:2716-17
