Polar Electro CE217 User manual

Safety Tips
Position on a flat, stable surface
A service agent/qualified technician should carry out installation and any repairs if required.
Do not remove and components or service panels on this product
Consult Local and National standards to comply with the following:
oHealth and safety at work legislation
oBS EN Codes of practice
oFire Precautions
oIEE wiring regulations
oBuilding regulations
DO NOT use jet/pressure washers to clean the appliance
DO NOT use the appliance outside
DO NOT use the appliance to store medical supplies
DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-cream makers etc)
DO NOT allow oil or fat to come into contact with the plastic components or door seal.
Clean immediately if contact occurs
DO NOT store products on top of the appliance
Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the
refrigerator
Always carry, store and handle the appliance in a vertical position and move by holding the
base of the appliance
Always switch off and disconnect the power supply to the unit before cleaning
Keep all packaging away from children. Dispose of the packaging in accordance with the
regulations of local authorities
If the power cord is damaged, it must be replaced by a POLAR agent or a recommended
qualified technician in order to avoid a hazard
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience or knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a person responsible
for their safety
Children should be supervised to ensure that they do not play with the appliance
This appliance is intended to be used exclusively for the storage of wine
Product Description
CE217 Polar Dual Zone Wine Chiller –92 Bottle Capacity
CE218 Polar Dual Zone Wine Chiller - 155 Bottle Capacity
Pack Contents
Polar Wine Chiller
Keys
Instruction Manual

Installation
Before using your wine chiller
1) Remove all the exterior and interior packaging
2) Before connecting the chiller to the power supply, let the chiller stand upright for
approximately 12 hours
3) Clean the interior with lukewarm water, using a soft cloth
4) The door can be opened from either the left or right side. When delivered, the door can be
opened from the left. Should you want to open it from the right, follow the instructions for
“reversing the door swing of your appliance”
Installing your wine chiller
1) The product is designed to be built-in, recessed, or free standing
2) Place the chiller on a floor that is able to support it once fully loaded. To level the chiller,
adjust the front levelling leg at the bottom of the chiller
3) Don’t place the chiller in direct sunlight or near other heat sources.
4) Avoid placing the chiller in damp areas
5) Plug the chiller into the socket.
6) Ensure that the air vent at the front of the chiller is never blocked or covered
Installing the handle
1) Remove the door gasket on the side you want to install the handle –there are two
designated holes for the handle installation
2) Install the handle tightly with two screws, lock washers and flat washers provided
3) Replace the door gasket
Operating you wine chiller
NB: the chiller should be placed in an area where the ambient temperature is between 16-35°C
When using the chiller for the first time, or re-starting it after a long period of time, there
may be a few degrees variance between the selected temperature and what is shown on the
LED readout. Once the chiller has been switched on for a few hours, this should rectify itself
If the unit is unplugged, has lost power or been turned off, wait 3 to 5 minutes before
restarting the chiller.

The controls of your wine chiller
Power
Light To control the inner light on/off
Up Used to increase the temperatures by 1°C
Down Used to decrease the temperature by 1°C
Select the temperature display setting in Fahrenheit or Celsius
& pressed simultaneously will lock / unlock the control panel
Wine Indicator Lights
Red LED for red wine
Green LED for white wine
Amber LED for sparkling wine
Setting the temperature control
1) When using the temperature controls for the first time, the LED will display the previous
temperature (the factory settings are 10°C for the upper zone and 16°C for the lower zone)
2) The degrees indicator will appear on the display marked for the upper zone and for the
lower zone
3) The temperature settings of each zone is adjustable with the range 5-18°C (40-65°F).
NB: the temperature for the lower zone must ALWAYS be the same or higher than the upper
zone
4) The temperature increases by 1°C or 1°F if you touch the UP button once, and will decrease by
1°C or 1°F if the DOWN button is touched once
5) When storing mainly red wine, the temperature should be set at 15-18°C, and the red LED will
be lit
6) When storing mainly white wine, the temperature should be set at 9-14°C, and the green LED
will be lit

7) When storing mainly sparkling wine, the temperature should be set at 5-8°C, and the amber
LED will be lit
8) To view the current temperature of the chiller, press either the UP or DOWN button and the
temperature will flash on the display for five seconds
Storage
CE217: 40 wine bottles can be placed in the upper zone - 8 bottles on each shelf. 52 bottles
can be placed in the lower zone –8 bottles on each full size shelf, and 6 on each half size
shelf
CE218: 77 wine bottles can be place in the upper zone –11 bottles on each shelf. 78 wine
bottles can be in the lower zone –11 bottles on each full
size shelf, and 6 on each half size shelf
NB: Bottle capacities are approximate maximums when storing traditional Bordeaux
750ml bottles and include bulk storage.
Shelves
To prevent damage to the door gasket, ensure the door is fully open when pulling shelves
out of the rail compartment.
For easy access to the bottles, pull the shelf out by about 1/3. The shelf will stop
automatically if they are being taken out too far when housing wine bottles. Only pull out 1
shelf at a time.
Cleaning, Care & Maintenance
Cleaning your wine chiller
1) Turn off the power, unplug the appliance and take out all items including shelves and racks
2) Wash the inside surfaces with a mild detergent
3) Wash the shelves with a mild detergent
NB: ensure that excess water is wrung out when cleaning any area of the controls
4) Wash the outside of the cooler with a mild detergent. Rinse well and wipe dry with a soft,
clean cloth