Pollmeier SE Touch-to-open User manual

Getting started
Electrically operated mortise lock
Touch-to-open

Getting started
Electronically operated touch-to-open mortise lock
Components
A
C
DE
B
D
SE lock
E
Planum SE handle set*
* The number and type of components may vary
depending on the handle set.

Installation step 1Prior to installation
www.smart-entrance.de
NOTE: refer to the separately enclosed handle guide
for the dimensions!
Drill/mill holes for handle installation
MADE IN GERMANY.
Instruction manual
Electrically operated mortise lock
Touch-to-open
Carefully read the instruction manual!

Installation step 3Installation step 2
Install the lock without battery compartment
A
B
Install the locking plate and the packing
Getting started
Electronically operated touch-to-open mortise lock
NOTE: turn the packing to vary the clearance of the
safety catch by 1 mm and adapt the contact pressure.
DE

www.smart-entrance.de
Installation step 4 Installation step 5
Install the handle Insert 4 x AAA 1.5 V micro alkaline batteries
NOTE: please refer to the separately enclosed
handle guide for instructions on handle installation!
NOTE: ensure correct polarity!
C

Installation step 7Installation step 6
Insert the battery compartment Switch on the lock and close the door within 10
seconds after the audible signal
B
e
ep
Getting started
Electronically operated touch-to-open mortise lock
C

9
x
b
e
ep
www.smart-entrance.de
Installation step 9Installation step 8
Do not touch the SE handle for 20 seconds during
the calibration process.
Open the SE handle within 20 seconds of the last,
slightly longer beep.
The lock is now ready for operation.
20s

09.2016_v1