POLTI AS 520 Parts list manual

®

AS520
1
2
2a
3a
34
89
67 11
5
C1
D
C2
C
G
A1
A
B
B1
F
E
E1
G1
10
14
7
8
11
Fig. 1 Fig. 2 Fig. 3 Fig. 4
Fig. 5 Fig. 6 Fig. 7
12
13
G1
15

LEGEND
1) Dust container
2) Dust container handle
2a) Dust container opening button
3) Dust container top lid
3a) Button to detach the dust container top lid
4) Button to detach the dust container
5) Connector hose
6) Carry handle
7) ON/OFF switch
8) Cable winder button
9) Cursor to adjust suctioning
10) Back Hepa filter grille
11) Power Supply cable
12) Type Hepa filter (fig.6)
13) Filter body with fine mesh (fig.6)
14) Back Hepa filter
15) Filter assembly (fig.6)
ACCESSORIES
A) Telescopic tube
A1) Telescopic tube locking button
B) Universal Brush
B1) Brush selector for carpets / floors
C) Hose handle
C1) Tube lock-in button
C2) Manual suction regulator
D) Hose
E) Small brush
E1) Bristle fitting for small brush
F) Lance for corners cleaning
G) Hook for parking
G1) Accessories holder (fig.5)
POLTI S.p.A., in accordance with its policy of con-
tinuous improvement, reserves the right to make
any technical and structural modifications without
prior notice.
This unit conforms to EC-directives 89/336
as amended by 93/68 (EMC) and 73/23 as
amended by 93/68 (low voltage).
WW
WWAA AARR RRNN NNII IINN NNGG GGSS SS
KEEP THESE INSTRUCTIONS
• Read these instructions for use carefully before
using the appliance.
• Any use which does not comply with these
instructions will invalidate the warranty.
• The wiring system to which the appliance is
connected must always comply with the laws in
force.
• Before connecting the appliance, make sure
that the mains voltage is the same as the volta-
ge indicated on the data label of the appliance
and that the power outlet is connected to earth
• Always turn off the appliance at the on/off switch
before unplugging it.
• If the appliance is left unused, always discon-
nect it from the mains. Never leave the applian-
ce unattended with the cable plugged into the
mains.
• Always make sure the appliance is unplugged
before performing maintenance work of any
kind
• Do not pull the power cord out of the socket, but
grasp the plug itself to avoid damage to the soc-
ket.
• Do not allow the power cord to be twisted, cru-
shed, stretched, or come into contact with sharp
or hot surfaces.
• Do not use the appliance if the power cable or
other important parts are damaged.
• Do not use electric extension leads that are not
authorized by the manufacturer, as they may
cause damage or fire.
• If it is necessary to replace the power supply
cable, please refer to the nearest Polti authori-
sed service centre, since the use of a special
tool is necessary.
• Never touch the appliance with wet hands or
feet with the cable plugged into the mains.
• Do not use the appliance when barefoot.
• Do not use the appliance near a bathtub, sho-
wer or container full of water
• Never immerse the appliance, the cable or the
plugs in water or another liquid.
• Use of the appliance in places where there is a
danger of explosions is prohibited.
• Do not use the product with toxic substances.
• Do not lay the hot appliance on surfaces sensi-
tive to heat.
• Do not leave the appliance exposed to wind or
rain.
• Do not place the appliance near a live element,
an electric stove or any other source of heat.
• Do not expose the appliance to extreme tempe-
ratures
• Never let children or people who are not familiar
AS520

with how the appliance works use it.
• Do not press the buttons hard or with a pointed
object such as a pen.
• Always rest the appliance on a stable surface.
• In case of accidental fall of the appliance it is
necessary to have it checked by an authorized
Service Centre as the internal safety features
may have been affected.
• In case of breakdown or malfunction switch off
the appliance and never attempt to disassemble
it, but refer to an authorized Service Centre.
• In order to avoid prejudicing the safety of the
appliance, use only original spare parts and
accessories approved by the manufacturer.
• Do not wind the power cord around the applian-
ce, especially when the appliance is still hot.
• Do not vacuum up liquids
• Do not use the appliance to suck up acids or
solvents, as these might cause serious damage
to the appliance and above all do not suck in
explosive dust or liquids, as these could cause
explosions on coming into contact with the insi-
de components of the appliance.
• Do not vacuum up toxic substances.
• Do not suck up burning or incandescent objects
such as embers, ash or other material in which
combustion is taking place.
CC
CCOO OORR RRRR RREE EECC CCTT TT UU UUSS SSEE EE OO OOFF FF TT TTHH HHEE EE PP PPRR RROO OODD DDUU UUCC CCTT TT
This appliance is intended for home use for suc-
king solids as described and in accordance with
the instructions provided in this manual. Please
read these instructions carefully and keep them,
as you may find them useful in future.
AA
AATT TTTT TTEE EENN NNTT TTII IIOO OONN NN
• This appliance is built according to current regu-
lations for recycling.
• Do not throw the appliance and packing mate-
rials used to protect the appliance during tran-
sportation, but take them to relevant collecting
centres.
• Filters are sold in authorised assistance centres
and in all major appliance shops.
• Use only original Polti spare parts.
•Polti declines liability for any damage or
accident derived from any use of this
appliance which does not comply with the
instructions contained in this booklet.
FF
FFUU UUNN NNCC CCTT TTII IIOO OONN NNII IINN NNGG GG
• Unroll the supply cable (11) till reaching the yel-
low sign on the cable itself, by pulling it as
shown in fig 1. DO NOT under any circumstan-
ces unroll beyond the red sign.
• Insert the suction opening on the hose (D) into
connection (5) (fig. 2).
• Plug into a suitable power outlet (fig.1).
• Press the ON/OFF switch (7). The appliance will
start operating. The ON/OFF switch (7) can also
be operated by touching it with your foot, so you
do not have to bend.
• It is possible to regulate suction power through
the slide cursor (9). Moving the cursor forward,
the power increases, moving the cursor back-
wards the power decreases. We recommend
minimum power for curtains, medium low power
for sofas, armchairs and cushions, medium high
for carpets and high for floors and hard surfaces
(ceramics, marble, etc.).
• Thanks to the manual suction regulator (C2),
the suctioning power can be changed according
to the cleaning task, and it allows to intervene
promptly in case of accidental suctioning (e.g. of
curtains). We recommend an open regulator on
curtains, carpets, sofas and so on. Move the
regulator backwards till uncovering the hole on
the hose. To suction again at maximum power,
move the regulator forward till covering the hole.
• To end suctioning, press again the ON/OFF switch
(7).
EE
EEMM MMPP PPTT TTYY YYII IINN NNGG GG AA AANN NNDD DD CC CCLL LLEE EEAA AANN NNII IINN NNGG GG OO OOFF FF TT TTHH HHEE EE
DD
DDUU UUSS SSTT TT CC CCOO OONN NNTT TTAA AAII IINN NNEE EERR RR
• Switch off the appliance (7). Disconnect the
supply cable (11) from the mains.
• Disconnect the flex hose (D) from the appliance,
by pressing the button (C1) and pulling it.
• Press the Button to detach the dust container
(4) on the top lid (3).
• Remove the dust container (1) holding it by the
handle (2).
• Press the switch (2a) on the handle (2) in order
to open the container and get rid of the collec-
ted dirt (Fig.3).
• ATTENTION: when pressing the switch (2a),
the underside of the container opens automati-
cally, so we recommend to empty the container
AS520

on a rubbish bin.
• Remove the filter assembly (15) and let possible
trace of dirt go out
• We recommend to clean the container after
each use.
• ATTENTION: DO NOT use the appliance
without dust container (1) and its filter.
• Put the dust container back in place.
UU
UUSS SSII IINN NNGG GG AA AACC CCCC CCEE EESS SSSS SSOO OORR RRII IIEE EESS SS
Accessories may be connected directly to the
hose (D) or to the telescopic tube (A)
Using the telescopic tube (A)
The tube is about 50 cm long when closed, about
80 cm when extended to its greatest length. To
increase or decrease length, press the button (A1)
and extend or reduce length as desired.
Using the universal brush (B)
Connect the brush to the telescopic tube. If you
move the selector on the brush (B1) and press
with a foot, you can change the suctioning surface
without bending down. The position with bristles
extended is recommended for all non-carpeted
floors. The position without bristles is recommen-
ded for carpets.
Using the Small Brush (E)
Thanks to its soft bristles, the small brush is suita-
ble for dusting delicate surfaces like frames,
books and so on…
The small brush can be used with or without bri-
stle fitting (E1). To separate the fitting from the
brush just pull it outwards (fig. 4).
Using the Lance for corners cleaning (F)
This lance is suitable for thorough cleaning of the
most difficult places, like skirting-boards, sofa
gaps, armchairs, upholstered furniture, car seats.
This accessory can be stored on the back of the
machine.
AA
AAUU UUTT TTOO OOMM MMAA AATT TTII IICC CC CC CCAA AABB BBLL LLEE EE WW WWII IINN NNDD DDEE EERR RR
Before putting the vacuum cleaner away, rewind
the power cable by pressing the button (8), being
careful to accompany the cable during winding.
UU
UUSS SSEE EE OO OOFF FF TT TTHH HHEE EE AA AACC CCCC CCEE EESS SSSS SSOO OORR RRII IIEE EESS SS HH HHOO OOLL LLDD DDEE EERR RR
The accessories holder (G1) allows you to fix the
tube with the brush mounted on it on the body of
the appliance. To attach the hose to the appliance,
slide the hook (G) on the hose into the accesso-
ries holder slot on the appliance (Fig.5 ).
GG
GGEE EENN NNEE EERR RRAA AALL LLMM MMAA AAII IINN NNTT TTEE EENN NNAA AACC CCEE EE
Always make sure the appliance is unplugged
before performing maintenance work of any kind.
Replacement and cleaning of the type Hepa fil-
ter (12) and the filter body with fine mesh (13)
• Remove the dust container (1) as described in
the paragraph “Emptying and cleaning of the
dust container”.
• Press the Button to detach the dust container
top lid (3a).
• Remove the filter from the container and sepa-
rate it as shown in fig. 6
• Rinse all elements under running water and let
them dry.
• Put all elements back in place.
Replacement and cleaning of the back Hepa
filter (14)
• Open the back Hepa filter grille (10) by moving
the lever on the grille (fig.7).
• Remove the back HEPA filter.
• Rinse the filter in cold running water. Shake it
gently after washing to eliminate any residual
dirt and excess water.
• Put the filter (14) and the grille (10) back in
place.
WARNING: HEPA FILTER (14) AND TYPE HEPA
FILTER (12)
• Let the filters dry naturally, away from light and
heat sources. You should wait 24 hours before
reassembling filters in the appliance.
• Replace the filters if they are torn.
• Filters should be cleaned every 4 months.
• Do not clean filters with a brush, as this could
damage them, decreasing their filtering capaci-
ty.
• Do not use detergents, do not scrape filters, and
do not wash them in a dishwasher.
AS520

EE
EELL LLEE EECC CCTT TTRR RRII IICC CCAA AALL LLSS SSAA AAFF FFEE EETT TTYY YY
No earth required.
Ensure the mains voltage suits your appliance.
Fitting the mains plug important
The wires in the mains lead are coloured in
accordance with the following code:
• Blue: Neutral
• Brown: Live
The wire which is coloured BLUE must be connec-
ted to the Terminal which is marked with the letter
“N” or coloured BLACK.
The wire which is coloured BROWN must be con-
nected to the Terminal which is marked with the
letter “L” or coloured RED.
It is important that the outer sheath is clamped
correctly into the 3-pin plug.
If in doubt consult your local Service Dealer or
qualified electrician before the machine is used.
A 13 AMP FUSE MUST BE FITTED TO THE
MAINS
PLUG.
AS520