Poly-Tech Industrial Gazuntite Desk Shield User manual

Patent Pending
3in
1in
2in
1. POSITION GRIPPERS IN
CORNER LOCATIONS
One at a time, use ruler on instructions to
measure 3 inches from corner for each gripper.
CLEAN SURFACE - Prior to installation, be sure desk surface is clean and dry.
Installation
1x
SHIELD
6x
ADHESIVE
GRIPPER
INSTALL VIDEO EXAMPLES
3in
3in
1
23
4
2.PEEL AND STICK GRIPPER
Stick each gripper down
by pressing it firmly onto desk
PEEL
( Repeat Step 1 & Step 2 for
each of the 4 Grippers )
FLIP
PAGE
Please read the instructions carefully before starting.
PRESS

3. PEEL FILM OFF SHIELD
THEN PUSH SHIELD INTO
GRIPPERS
4. POSITION EDGE GRIPPERS
5. PEEL AND STICK EACH
EDGE GRIPPER PER STEP 4
Use ruler on instructions to
position grippers 1 inch from
the edge of the shield
HINT: Build a template for
quicker installation on
Identical Desks.
PUSH
PUSH
PEEL
Only 4 grippers
should be installed
at this point
Make sure shield is
centered
1in
1in 1in 1in
56
PUSH
PUSH
HINT:
Build a template
for quicker
installation on
identical desks.
PEELPEEL
PRESS
Only 4 grippers
should be installed
at this point
Measure and Cut template as shown below,
then mark Gripper locations.
V 1.1 08.06.20 Poly-Tech Industrial, Inc.