POP UP ALPHA DECK User manual

1. Warning, fall from the ladder.
2. Refer to instruction manual/booklet.
3. Inspect the ladder after delivery. Before every use visually
check the ladder is not damaged and is safe to use. Do not
use a damaged ladder.
4. Maximum total load 150kg.
5. Do not use the ladder on a unlevel or unfirm base.
6. Do not overreach.
7. Do not erect ladder on contaminated ground.
8. Maximum number of users: 1
9. Do not ascend or descend unless you are facing the
ladder.
10. Keep a secure grip on the ladder when ascending and
descending. Maintain a handhold whilst working from a
ladder or take additional safety precautions if you cannot.
11. Avoid work that imposes a sideways load on ladders, such
as side-on drilling through solid materials.
12. Do not carry equipment which is heavy or difficult to
handle while using a ladder.
13. Do not wear unsuitable footwear when climbing a ladder.
14. Do not use the ladder if you are not fit enough. Certain
medical conditions or medication, alcohol or drug abuse
could make ladder use unsafe.
15. Do not spend long periods on a ladder without regular
breaks (tiredness is a risk).
16. Prevent damage of the ladder when transporting e.g. by
fastening and, ensure they are suitably placed to prevent
damage.
17. Ensure the ladder is suitable for the task.
18. Do not use the ladder if contaminated, e.g. with wet paint,
mud, oil or snow.
19. Do not use the ladder outside in adverse weather condi-
tions, such as strong wind.
20. For professional use a risk assessment shall be carried
out respecting the legislation in the country of use.
21. When positioning the ladder take into account risk of colli-
sion with the ladder e.g. from pedestrians, vehicles or doors.
Secure doors (not fire exits) and windows where possible in
the work area.
22. Warning, electricity hazard. Identify any electrical risks in
the work area, such as overhead lines or other exposed elec-
trical equipment and do not use the ladder where electrical
risks occur.
23. Use non-conductive ladders for unavoidable live electrical
work.
24. Do not use the ladder as a bridge.
25. Do not modify the ladder design.
26. Do not move a ladder while standing on it.
27. For outdoor use caution to the wind.
28. If a ladder is delivered with stabilizer bars and these bars
should be fixed by the user before the first use this shall be
described on the ladder and in the user instruction.
29. Ladder for professional use.
30. Do not step off the side of standing ladder onto another
surface.
31. Open the ladder fully before use.
32. Use the ladder with restraint devices engaged only, ex:
stabiliser; ballast; activated brakes – if part of the ladder.
33. Any horizontal surface which looks like a platform on a
standing ladder that is not designed for standing on (e.g. a
plastic work tray) shall be clearly indicated on that surface,
(only if necessary due to
design of ladder).
34. Do not use ladders outdoors which are not intended for
this purpose.
35. For platform heights greater than 2,5 m, the safety
instructions shall specify if a product cannot be used outside
(Outdoor use is allowed if the product passes the required
stability test described in 6.7.).
36. For outdoor use caution to the wind.
REPAIR, MAINTENANCE AND STORAGE
Repairs and maintenance shall be carried out by a compe-
tent person and be in accordance with the producer’s
instructions.
NOTE A competent person is someone who has the skills to
carry out repairs or maintenance, e.g. by a
training by the manufacturer.
For repair and replacement of parts, e.g. feet, if necessary
contact the producer or distributor.
Ladders should be stored in accordance with the producer’s
instructions.
Ladders made of or using thermoplastic, thermosetting
plastic and reinforced plastic materials should be stored
out of direct sunlight.
Ladders made of wood should be stored in a dry place and
shall not be coated with opaque and vapour-tight paints.
LIST OF ITEMS TO BE INSPECTED
For regular inspection, the following items shall be taken into
account:
— check that the stiles/legs (uprights) are not bent, bowed,
twisted, dented, cracked, corroded or rotten;
— check that the stiles/legs around the fixing points for
other components are in good condition;
— check that fixings (usually rivets, screws or bolts) are not
missing, loose, or corroded;
— check that rungs/steps are not missing, loose, excessively
worn, corroded or damaged;
— check that the hinges between front and rear sections are
not damaged, loose or corroded;
— check that the locking stays horizontal, back rails and
corner braces are not missing, bent, loose,
corroded or damaged;
— check that the rung hooks are not missing, damaged,
loose or corroded and engage properly on the;
rungs;
— check that guide brackets are not missing, damaged,
loose or corroded and engage properly on the
mating stile;
— check that ladder feet / end caps are not missing, loose,
excessively worn, corroded or damaged;
— check that the entire ladder is free from contaminants
(e.g. dirt, mud, paint, oil or grease);
— check that locking catches (if fitted) are not damaged or
corroded and function correctly;
— check that the platform (if fitted) has no missing parts or
fixings and is not damaged or corroded.
Any damaged element must be replaced by a component
identified by the manufacturer.
If any of the above checks cannot be fully satisfied, you
should NOT use the ladder. For special ladder types, further
items identified by the manufacturer shall be taken into
account.
EN 131
ASSEMBLY INSTRUCTIONS
INSTRUCTIONS FOR USE
01
05
02
03
04
EQUIPMENT DISASSEMBLY
Start with step D1 (press both triggers at the same time)
and follow the reverse order of assembly.
D1
ALPHA DECK™
THE ASSEMBLY AND USE INSTRUCTIONS IN THIS
MANUAL ARE ONLY VALID FOR ALPHA DECK
AND ALPHA DECK PLUS PLATFORMS.
DON’T USE THE ALPHA DECK IF THERE’S ANY
MISSING PART. COMPONENTS SHOULD NOT BE
MODIFIED FROM IT’S ORIGINAL.

ALPHA DECK PLUS™ALPHA DECK™
ALPHA DECK PLUS™ LATERAL STABILIZERS
A1 B1
B2
B3
A2
A3
0,46m 2,46m 1,51m 0,56m 1,96m 0,34m 17,09kg25604620060021
0,93m 2,93m 1,98m 0,56m 2,45m 0,34m 19,85kg45604620060045
22,44kg1,40m 3,40m 2,45m 0,56m 2,95m 0,34m65604620060069
0,70m 2,70m 1,74m 0,56m 2,20m 0,34m 18,54kg35604620060038
1,17m 3,17m 2,21m 0,56m 2,70m 0,34m 21,15kg55604620060052
1,65m 3,65m 2,68m 0,56m 3,20m 0,34m 23,75kg75604620060076
Min 0,72m
Max 0,95m
Min 1,80m
Max 2,03m
Min 2,72m
Max 2,95m 0,67m 2,23m 0,48m 24,30kg3-45604620060137
Min 1,19m
Max 1,89m
Min 2,27m
Max 2,97m
Min 3,19m
Max 3,89m 0,67m 2,74m 0,48m 30,13kg5-85604620060151
Min 0,95m
Max 1,42m
Min 2,03m
Max 2,50m
Min 2,95m
Max 3,42m 0,67m 2,49m 0,48m 27,08kg4-65604620060144
ALPHA DECK PLUS™
ALPHA DECK™
ALPHA DECK™
EN 131
ASSEMBLY INSTRUCTIONS
[phone] [email protected] popupproducts.co.uk
THE ASSEMBLY AND USE INSTRUCTIONS IN THIS
MANUAL ARE ONLY VALID FOR ALPHA DECK
AND ALPHA DECK PLUS PLATFORMS.
DON’T USE THE ALPHA DECK IF THERE’S ANY
MISSING PART. COMPONENTS SHOULD NOT BE
MODIFIED FROM IT’S ORIGINAL.
TECHNICAL
INFORMATION