Little Giant CONQUEST ALL-TERRAIN User manual

CONQUEST ALL-TERRAIN™
OUTRIGGER OPERATION AND MAINTENANCE
Standard on CONQUEST ALL-TERRAIN™models, the
outriggers provide additional width at the base of the
ladder for added stability, and function as built-in levelers,
allowing the ladder to be used safely in unlevel areas. The
outriggers have a pressure sensitive safety mechanism,
which doesn’t allow them to be released if someone is on
the ladder.
Release handle
Outrigger Operation:
1. To unlock, lift or tilt the
ladder slightly to remove
any pressure on the foot of
the side you’re adjusting.
2. Squeeze the release with your
fingers. Then, while holding the
release in the unlocked position,
press down the lock housing and
nudge the ladder foot outward.
3. When you get the outrigger to the desired
position, let go of the release and move the
housing slightly until you feel it lock into
place. Even when used on level ground,
both outriggers should be extended to the
first locking position below the storage
position for additional stability.
4. To avoid injuries caused by misstepping as you dismount the ladder, it is highly recommended
that the outriggers are used for leveling only, and not for gaining additional height. Try to keep the
bottom rung height approximately 12" from the ground. Never fully extend both outriggers at the
same time. When leveling the ladder, keep one outrigger set in the 1st Use Position, then extend the
other until the ladder is level side-to-side.
Advised Use
Positions
Non-Use
Positions
NEVER USE
LADDER WITHOUT
OUTRIGGERS DEPLOYED.
ALWAYS MAKE SURE
LOCKING PIN IS FULLEY
ENGADED BEFORE EACH USE.
12”
[30 cm]
>
Use ladder only in advised positions shown.
Use in any other position may result in death or serious injury.
84336 V1 10.22

CONQUEST ALL-TERRAIN™
OUTRIGGER OPERATION AND MAINTENANCE
Maintenance:
84336 V1 10.22
CONTINUED
To keep your outriggers operating smoothly, lubricate them with a dry
lubricant at least every six months, and prior to long term storage, or
more often as use dictates, and under extreme weather conditions.
For the following instructions, the ladder can be
laying down in storage mode or set up in A-frame
configuration.
1. Extend the outrigger as shown in figure 1.
2. Using only a dry lubricant, spray inside the
small center hole shown in figure 2.
3. Extend and retract the outrigger a couple
times, allowing the lubricant to coat the handle
evenly.
Dry lubricant suggesstions: 1. DuPont 2. Tri-FLow 3. B’Laster
Little Giant Ladder Systems, LLC
1198 North Spring Creek Place
Springville, UT 84663 USA
LittleGiantLadders.com
Still need help?
Call our support team at:
800 - 453 - 1192
Monday - Friday 7am - 5pm MST
Or visit us online:
LittleGiantLadders.com
We’d be happy to help!
Fig. 2
Fig. 1
• Never adjust the outriggers while you are on the ladder.
• Never adjust the outriggers if anyone is on the ladder.
• Always make sure your ladder is level side-to-side before
climbing.
• Never release the outriggers if someone is on the ladder.
• Never use the ladder without outriggers deployed.
• Always make sure the locking pins are fully engaged before
each use.
• To avoid missteps, keep the bottom rung approx. 12 inches
(30 CM) from the ground.
FAILURE TO OBSERVE THE FOLLOWING MAY RESULT
IN SERIOUS INJURY OR DEATH.
WARNINGS