Porta-Dock F55 User manual

11/11/03
U:\Judy\INSTRUCTIONS CURRENT\INSTR DOCK ACCESSORIES\A18 INSTR BENCH KITS PD.doc
PORTA-DOCK, INC.
F55 POST DOCK BRACKET TYPE CEDAR BENCH KIT COMPLETE 44”
F95 POST DDOCK BRACKET TYPE CEDAR BENCH KIT COMPLETE 56”
F56 WHITE F56B BEIGE POST DOCK BRKT TYPE ALUMINUM BENCH KIT COMPLETE 48”
F96 WHITE F96B BEIGE POST DOCK BRKT TYPE ALUMINUM BENCH KIT COMPLETE 60”
Thank you for purchasing our product.
Please read these instructions and follow them step by step.
Step 1. Slide the bench support bracket (REF # 4) over the
uprights of the bench side. Secure in place with 1/2” X 1” set
screw (REF # 9). Bolt on the back of the bench as shown in the
seat and back mounting instructions.
Step 2. Install the bench mounting brackets to the post dock
using 1/2” X 2” set screws (REF # 8), leave finger tight at this
time. Slide a post into the pocket on the bench support bracket,
secure in place with a 1/2 X 1” set screw (REF. # 9). Bolt the
bench into the bench mounting brackets using 3/8” X 3” bolts,
washers, and nuts (REF. # 7, 6, 5). Set the post to the desired
height, tighten all bolts and set screws at this time.
REF.# PART # DESCRIPTION QTY
2 C00 BENCH SIDE ALUM 2
3 F22 BENCH PD MTG BRKT 2
4 J01 BENCH PD SUPPORT BRKT FOR POST 1
5 5056 NUT FIN 3/8” 2
6 5070 WASHER 3/8” 4
7 5132 BOLT 3/8” X 2 ¾" GR 2 2
8 5173 SET SCREW ½” X 2” 4
9 5174 SET SCREW ½ X 1” 3
2- 37
POST PURCHASED SEPERATLY
DUE TO VARYING WATER DEPTHS

Porta-Dock, Inc.