Portable Bar Company COMPACT BAR User manual

Table of contents:
- Part List
- Set Up Guide
- Compact Bar Covers
COMPACT BAR SET UP GUIDE

2BEFORE YOU BEGIN THE INSTALLATION
• Read all the instructions before installing.
• Remove all packing materials before you start.
• Remove all protection films from acrylic panels.
• This installation requires basic mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under
the warranty.
• Keep this instruction manual.

Main Frame
QTY: 1
Counter Top
QTY: 1
Speed Rail
QTY: 1
Ice Bin
QTY: 1
Lock Pin
QTY: 5
Acrylic Panel
QTY: 4
Cutting Board
QTY: 1
Cover
QTY: 1
See page 7
PART LIST
Note: Parts are not to scale.
3

STEP 1: Remove the pins and . Unlock the spring
latches at the bottom ( - ).
P1 P2
L1 L2
P1
P2
L1
L2
STEP 2: Open the doors as shown below.
Figure 1
Figure 2
CAUTION: The doors slide down when fully open. See Figure 3.
Figure 3
STEP 3: Place the side pins as shown below ( - ).
Remove pins and .
P1 P2
P3 P4
P3
P1
P2
P4
Figure 4
Note: Adjust levelers to desired
lenght for added stability.
Note 2: Pins and may look
like the pin below:
P1 P2
COMPACT BAR ASSEMBLY SET UP STEPS
4

STEP 4: Lift the shelf and place the pins and
as shown below.
P3 P4
STEP 5: Set down the shelf and remove the pin
as shown below.
P5
STEP 6: Insert the pin .
P5
P3
P4
P5
P5
Figure 5
Figure 6
Figure 7
STEP 7: Place the counter top as shown below. Lock the counter
top in place using the two spring latches and
L3 L4
L3
L4
Figure 8
COMPACT BAR ASSEMBLY SET UP STEPS 5

STEP 8: Place the speed rail and the ice bin
as shown below.
Figure 9
Figure 10
How to remove the acrylic panels if needed
Back Panel
STEP 1: Remove screws and . Then remove
the tab as shown below.
S1 S2
S1
S2
STEP 2: Pull up the acrylic panel.
STEP 1: Remove screws and . Then remove
the side frame as shown below.
S3 S4
STEP 2: Slide out the side panel.
STEP 1: Remove screws and . Slide out the panel.
S5
S6
S3
S4
S5
S6
Side Panel
Top Panel
COMPACT BAR ASSEMBLY SET UP STEPS
6
ON ACRILYC PANELS ONLY
Remove the brown protective film on one or both sides before installing
the panels, otherwise, the panels could warp. If you got vinyl printing,
the protective film will only be on one side. Don't remove the vinyl printing.

Figure 11. Full Assembly.
Notes to remember
Do not move bar long distances fully stacked.
Roll up levelers before moving bar.
Do not roll bar over uneven surfaces.
Two persons required to move bar.
COMPACT BAR ASSEMBLY SET UP STEPS 7

Speed rail cover
Main frame cover
Counter cover
COMPACT BAR ASSEMBLY SET UP STEPS
8

Contact us
Tel # [phone]
Fax # [phone]
E-mail: [e-mail]
Visit us at
www.theportablebarcompany.com
COMPACT BAR SET UP GUIDE - 10/2020