Portable Bar Company Distressed Bar User manual

Note: This setup requires 2 or more persons.
• Read all the instructions before installing.
• Remove all packing materials before you start.
• This installation requires basic mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under
the warranty.
• Keep this instruction manual.

Main Frame
QTY: 1
Note: Parts are not to scale.
PART LIST
Ice bin/Cover
QTY: 1
Drainer
QTY: 1
Laminated Base
Panels
QTY: 2
(Add-on only)
Counter
QTY: 1
Speed Rail
QTY: 1
Locking Pin
QTY: 2

DISTRESSED BAR DISASSEMBLY STEPS
STEP 2: Take the icebin out.
STEP 1: Mount the speed rail to the bar, as shown below:
TO COMPLETE THE SETUP OF THE BAR:
Figure 1
STEP 1: Dismount the speed rail.
DISASSEMBLY STEPS:
Figure 3
Figure 4
Figure 2
STEP 2: Install the drainer as shown below:

DISTRESSED BAR ASSEMBLY SETUP STEPS
STEP 4: Use the spring latches located at both sides of the
shelf to release it. Do it carefully, once you release it
the shelf will fold down.
Figure 6
Figure 7
Figure 5
STEP 3: Use the spring latches located at the sides of the
counter to release it.
Note: This step requires two people.

STEP 7: Place the counter on top of the folded position of
the base. Use the posts located at the sides of the
counter to keep it in place.
DISTRESSED BAR ASSEMBLY SETUP STEPS
STEP 5: Remove the locking pins located at the sides of the
base panel. Then fold the side panels by slightly lifting
them up.
Figure 10
Figure 9
STEP 6: Unscrew the star knobs located at both sides of the
bar. Tighten the star knobs after folding the base,
as shown below:
Figure 11
Figure 12
STEP 7: Cover the ice bin and store it along with the speed rail
as shown below:
Figure 8

• Read all the instructions before installing.
• Remove all packing materials before you start.
• This installation requires basic mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under
the warranty.
• Keep this instruction manual.

LED Controller
QTY: 1
Battery
QTY: 1
Note: Parts are not to scale.
PART LIST
Power Cord
QTY: 1
Remote Controller
QTY: 1
Counter w/LED strip
QTY: 1

LED KIT SETUP GUIDE
STEP 1: The LED controller will arrive pre-wired and with velcro
tape applied. Choose a location that best fits your
needs with applying it to the back panel beneath
the working surface or on the under side of the
working surface by removing the tape backing.
STEP 2: Connect the cable from the LED controller to the LED
strip attached to the top counter via the male and
female plugs.
STEP 3: Plug the battery (or power cable) into the controller
to turn on LED system with the provided cable. Place
the battery on the base on the bar. .
Note: When disassembling and folding the bar, unplug the LED
strip from the controller when removing the counter to
avoid damages.
Figure 2
Figure 1

Contact us
Tel # [phone]
866-659-3353
[e-mail]
Fax #
E-mail:
Visit us at
www.theportablebarcompany.com