Portable Bar Company Flash Bar User manual

Flash Bar
Set Up Guide
Table of Contents
- Single Straight Segment Assembly
- Straight Add-on Assembly
- Corner Add-on Assembly
- LED Strip Connection
- Straight Counter Installation
- Side Cap Installation
- Lock Counter in Place
- Speed Rail Installation
2 - 5
6
7 - 9
10
11
11
12
13
1

Single Straight Segment Assembly
1
2
Join side frame and feet
together and tighten up
with wing nuts.
2

Align each pin on front panel with holes on side
frame to join front panel and side frames.
3
3

To attach top front panel to side frames,
align each pin with holes on side frame.
4
4

Slide shelves into side frame.
5
5

Straight Add-on Assembly
Repeat steps from 1 to 5
for each straight segment
to extend your Flash Bar.
6

Corner Add-on Assembly
1
2
7

4
3
8
To attach corner top
front panel to side
frames, align each
pin with holes on side
frame.

5
6
9
Place counter onto
the top of side frame.

LED Connection
(Skip this page if your Flash Bar doesn’t have LED.)
LED connection between straight segments
LED connection between straight segment and corner segment
1 2
2
Corner counter
WARNING:
Don’t place on straight counter
before LED connection is
complete.
Corner counter
WARNING:
1. Don’t place LED cables
in the channel where the
straight counter ts.
2. Don’t place on straight
counter before LED
connection is complete.
Clip
Clip
10
1

Straight Counter Installation
Side Cap Installation
11

Lock Counter in Place
12
Secure counters by
inserting pins through the
holes in the counter and
side frame.

Speed Rail Installation
1
2
13