PortaPivot STEALTHPIVOT PAP-LOCK User manual

PAP LOCK
ASSEMBLY & INSTALLATION
By PortaPivot

Detach all the plastic
parts from each other.
2 X M4X10
1 X LOCK BOLT
1 X M5X45
1 X M5X60
1 X PAP-SLA-SET
1 X PAP-SLC-SET
1 X PAP-SLB-SET
PAP LOCK PARTS

M5X45
(IF YOU WANT TO USE SLIDING LOCK
ON BOTH SIDES OF THE DOOR PANEL,
USE M5X60MM)
PAP LOCK ASSEMBLY

M4X10
M4X10
M4X10
M4X10
LOCK BOLT UP
= ROTARY LOCK
LOCK BOLT DOWN
= SLIDING LOCK
ROTARY LOCK INSTALLATION
SLIDING LOCK INSTALLATION

Carefully snap cover
plate* in place
Can be mounted on both
sides of the door panel
Can be mounted on both
sides of the door panel
Mount on 1 side of the
door panel in combination
with sliding or turning
lock plate
ROTARY LOCK PLATE SLIDING LOCK PLATE PRIVATE PLATE
ARROW OR OPENING SHOULD
ALWAYS FACE DOORPANEL EDGE
LOCK COVER INSTALLATION

“CLICK”
ROTARY LOCK OPERATION
SLIDING LOCK OPERATION

Install the door jamb rubbers
above and below the cutout
Click the lock bolt receiver in place
OPENING UP
= ROTARY LOCK
OPENING DOWN
= TURNING LOCK
DOOR JAMB LOCK BOLT RECEIVER

DG.08/11/12
HORIZONTAL
ON GLASS
5730
WITH LOCK
5730
WITHOUT LOCK
DG.08/11/12
VERTICAL
ON FRAME
DG.10
500/750/1130/DOORHIGH
ON FRAME
UGP
750/1130/DOORHIGH
ON GLASS
DG.10
500/750/1130/DOORHIGH
ON GLASS
UGP
750/1130/DOORHIGH
ON FRAME
YES
NO
YES
NO
YES
NO
YES
YES
YES
YES
YES
YES
LOCK & DOORHANDLE COMBINATIONS

For instructions on how to install
the fully assembled door in your doorway,
please refer to the DOOR INSTALLATION MANUAL