POVISON DT046AW14 User manual

Serial
number Shape Name Quantity
Parts list
A8
Product name:DT046AW14/16
RECOMMENDED NUMBER OF INSTALLERS: 2
Installation instruction
Flathead machine screws
(M8*60)
TotaL 1 page; page 1
1.Confirm installation steps (please verify the list when unpacking)
①Please read the manual carefully
before installing this product.
And strictly follow the
installation process
② Please take good care of this
manual for your next installation
B
Self-tapping screws
(M4*16)
6
C
16
Gaskets
2.Upside down the stand and the base, connect with hexagonal machine
wires and gasket.
3.Connect the frame with table legs.
①
②
③
(1).Put the flat head machine
wire in the place where the
support frame is connected
with the table leg, and
tighten it with an Allen
screwdriver.
(2).Place the desktop on top of
the support frame, and tighten
the frame and the support frame
with self-tapping screws.
(1).Put the hexagonal machine wire in
the hole and tighten with a wrench.
Flathead machine screws+Gaskets
（M8*20mm）
Flathead machine screws+Gaskets
（M8*60mm）
4.Installation finished.
Flathead machine screws
(M8*20)
8
D
Self-tapping screws
(M4*16)

DT046AW18/20 Installation
The number of people needed for
installation：2
TotaL 1 page; page 1
Serial
number Shape Name Quantity
①Please read the manual carefully
before installing this product.
And strictly follow the
installation process
② Please take good care of this
manual for your next
installation
Installation instruction
Parts list
1.Connect the desktop frame and the table legs to each other, align
the hexagonal wire with the holes and put it in (tighten the screws
to 3/2 and wait for the base to be installed before tightening)
2.Place the base on the bottom of the table legs to adjust the
alignment of the holes, then put in the hexagonal wire and tighten
it with a wrench.
3.Put the desktop on the frame, put the self-tapping screws on the
frame ears, and tighten them with a screwdriver or electric drill.
4.Installation complete
A
B
24
C
Hexagonal wire
(M8*20mm)
Adjusting feet
Self-tapping screws
（M4*16mm）
6
Gasket
24