POVISON TS1021BL User manual

TS1021BL Installation
The number of people needed for
installation：2
TotaL 1 page; page 1
Serial
number Shape Name Quantity
①Please read the manual carefully
before installing this product.
And strictly follow the
installation process
② Please take good care of this
manual for your next
installation
Installation instruction
Parts list
1.Take out the drawers on the cabinets. 2.Find the holes in the inner panels of the cabinets on both sides,
put in the hexagonal wire, and connect with the middle cabinet.
After combining the three cabinets, just put the drawer back.
A8
Hexagonal wire
（M8*30mm）
3.The installation is complete.

Disassembly and assembly instructions
for two bottom buffer rail drawers
1.Two-section bottom buffer guide rail.
The way to teardown
drawer:
3.The way to
install drawer:
Disassembly buckle
Pull out the disassembly
buckle of the two guide
rails below the drawer at
the same time. Gently pull
the drawer up, and then you
can take the drawer down.
Pull out the disassembly
buckles
Bottom of drawer
Corresponding hole
location
Pull out the
disassembly
buckles
Check and make sure
the disassembly
buckle has been
pulled out.
Pull out the
disassembly
buckles
Hold the drawer, put
the holes on the
drawers into the
two-section bottom
buffer guide rail, and
then press down the
buckle to remove it.
Repeatedly push and pull
the drawer (2-4 times) to
check whether the drawer
has been install on the
guide rais properly. If
not , remove the drawer
and reinstall.
A total of 1 page; Page 1