PowerBox T200 User manual

PORTABLE POWER SUPPLY
T200 User Manual
Thank you for purchasing this multifunctional lithium power generator.
This unit will provide portable power with a range of AC / DC / USB outputs, to keep your smart phones,
tablets, lights & other small electrical devices charged & operating.
Before using this unit, please read the user manual carefully and retain it for future reference.
ATTENTION:
1. This product has an AC voltage output( 100V-240V/50Hz-60Hz). Keep out of reach of children when in use,
and store safely, to avoid the risk of electric shock.
2. This is universal user manual, AC output sockets, AC output voltage, AC output frequency and AC charger
plug will be different according to different countries and areas. Please read this user manual carefully before
using the unit, and check carefully that the unit’s voltage output matches your electric appliance’s voltage. This
is important to ensure that you do not damage your electrical appliance.
3. This unit is designed for temporary outdoor and emergency use only. It cannot replace normal alternating
current supply.

INTRODUCTION
【Product Parameters】
Battery
Lithium Ion Battery
Battery Capacity
222WH/60000mAh/3.7V
Dimensions(Length*Width*Height*Total Height)
210*139*123*180MM
Weight
2.32Kg
Input Recharging
AC Adapter: DC15V/3A
Solar Panel: MPPT, 14V-22V/3A (Max)
Fully Charged Time
DC15V/3A: 6-7 hours
DC Output
4 x DC5521: 9-12.6V/10A (15A Max)
USB Output
2×USB-A: 5V/2.4A
1×USB-A: QC3.0, 3-12V/18W
1×TYPE-C: QC3.0, 3-12V/18W
AC Output
Rate Power: Modified Sine Wave 200W
AC Voltage: 100/110/120/220/230/240V
Output Frequency: 50/60Hz
☆For actual voltage and frequency, please
refer to the sticker at the bottom of the unit.
LED Light
3W Ultra bright LED Flashlight
Power Indicator
LED Display
Operating Temperature
-10℃～ +40℃
Lifecycle
1000 times
Package Contents
1×Portable Power Supply 1×AC Adapter
1×Car Charger 1×Cigarette Lighter Adapter
1×User Manual
【Product Description】
☆AC outlets, AC output voltage and frequency will vary according to different countries or areas.
Please refer to the actual product before use. AC details are shown on the base of the unit.

【LED Display】
DC OUTPUT
This unit has 4x DC5521 outputs (voltage range: DC9V-12.6V and rated current is 10A (15A Max)).
To use, connect the power cable plug of the DC electric appliance to the DC outlet of the unit (as below). Switch
on the “DC button”. The DC indicator on the LED display will light up, and the unit will start providing power to
your DC12V appliance.
In addition, you can charge car accessories by connecting the Cigarette Lighter Adapter to the DC Outlet of the
unit (as below). Switch on the “DC button” ,the DC indicator will light up, and start charging DC12V car
accessories.
When there are no active charging sessions, the DC output will automatically switch off after 30 seconds, and
the unit will enter a low power state.
1. How to charge DC12V appliances with this unit?
2. How to charge car accessories via DC to Cigarette Lighter Connector?

Protection Modes:
This unit features a range of inbuilt safety features to help protect both this unit, and devices connected to it.
These protection features include the following.
1. Low-Voltage Protection: to protect the battery from over-discharge. When the battery is running out of
power, the DC output will automatically turn off. Please ensure that the unit is sufficiently charged.
2. Over- Voltage Protection: to protect the electric appliance from burnout. When the battery voltage is
detected as too high, the DC output will automatically turn off. And please return it to factory for processing.
3. DC Over-Current Protection: when the total current of DC electric appliances exceeds the maximum
allowable current, the DC output will automatically turn off. Please remove some of electric appliances and
restart the unit.
4. DC Short-Circuit Protection: when the DC output is short-circuited or overpowered, the DC output will
automatically turn off. Please resolve the problem and restart the unit.
USB OUTPUT
This unit has 2x USB-A (5V/2.4A) outputs, 1x USB-A QC3.0 Quick Charge output, and 1x TYPE C QC3.0 output.
Connect the USB cable of the electric appliance to the USB outlet of the unit (as below). Switch on the “DC
button”, the USB indicator on the LED display will light up, and the unit will start charging your 5V appliances
such as smart phones, tablets, Bluetooth speakers, etc.
When there are no active charging sessions, the DC output will automatically switch off after 30 seconds, and
the unit will enter a low power state.
Protection Modes:
1. Low-Voltage Protection: to protect the battery from over-discharge. When the battery is running out of
power, the USB output will automatically turn off. Please ensure that the unit is sufficiently charged.
2. Over- Voltage Protection: to protect the electric appliance from burnout. When the battery voltage is
detected as too high, the USB output will automatically turn off. Please return it to factory for processing.
3. USB Over-Current Protection: when the USB current exceeds the maximum allowable current, the USB
output will automatically turn off. Please remove the electric appliance, and it will restore automatically.
4. USB Short-Circuit Protection: when the USB output is short-circuited, the USB output will automatically turn
off. It will automatically restore after the load is removed.
5. Over-Temperature Protection: during the use of USB output, when the output voltage is large and
temperature becomes high, the USB output will automatically turn off. After the temperature drops, USB
output will restore automatically.
Notice: Lock Mode
Some smart devices like Bluetooth headphones and smart watches, require very small input current to charge,
which could be less than current detection limitation of the unit. Any such smart devices will not be able to be

charged by the standard USB charging function of this unit.
To be able to recharge such devices, long press the “DC button” for 3 seconds. This will turn the “DC Lock On”
to keep the USB port output running. Please press the “DC button” to turn off “DC Lock On” when the USB
device is fully charged to save power.
When the “DC Lock On” mode is on, the “DC Output” and “USB Output” icons on the LED display will keep
blinking. When “DC Lock On” is turned off, the two icons will stop blinking and become solid. DC outputs and
USB outputs will turn off.
AC OUTPUT
This unit has 1x AC Output(100V-240V/50-60Hz, rated power:200W/280W Max, peak power:400W.) The
detailed specifications will be customized according to different countries and areas. Please refer to the base of
the unit for your specifications.
To use, connect the power cable plug of the electric appliance to the AC outlet. Switch on the “AC button”, the
AC indicator on the LED display will light up, and the unit will start providing power to your appliances.
Protection Modes:
1. Low-Voltage Protection: to protect the battery from over-discharge. When the battery is running out of
power, the AC output will automatically turn off. Please ensure that the unit is sufficiently charged.
2. Over- Voltage Protection: to protect the electric appliance from burnout. When the battery voltage is
detected as too high, the AC output will automatically turn off. Please return it to factory for processing.
3. Over-Current Protection: when the current of the electric appliance exceeds the maximum allowable current,
the AC output will automatically turn off. Please check carefully that the power of your electric appliance is
within the power range allowed by this unit.
4. Short-Circuit Protection: when the AC output is short-circuited, the AC output will automatically turn off.
Please resolve the problem and restart the unit.
5. Over-Temperature Protection: during the use of AC output, the unit will generate heat. If the temperature
becomes too high, the inbuilt fan will automatically start to dissipate heat. This is normal.
Notice:
1. This unit has a “3 second” delay from pressing the AC button to AC voltage output. This is a soft start delay
design. This is normal.
2. In the event of over-current protection or short-circuit protection occurring, this unit will try to restart three
times in order to eliminate the protectionmalfunction caused by a high starting current but low working
current of electric appliances. After restarting, AC output will be turned off and will show on LED Display that
AC is wrong.
3. When the AC output is on, the inbuilt fan will turn on automatically every 5 minutes, so as to better dissipate
heat. Please turn off the AC output after using it.
4. If the ambient temperature is high and the power consumption is large, even if the inbuilt fan is on, the
product heat may accumulate to reach the overheat protection value. At this time, please turn off the AC
output to protect the inside components from over temperature damage. And use this unit again after the
temperature drops, or reduce the load power.
5. In the event of the battery capacity is about to run out, the low-voltage protection of AC output will be
turned on before that of DC output, so as to make better use of the remaining power. When the battery has

only 25% power or less, the DC output can be turned on normally while AC output can not, which is normal.
Warning:
1. Before using the AC output, you must confirm that the AC output voltage and frequency of this unit is
matched with those of the electric appliance, so as not to damage the appliance.
2. The power of AC electric appliances you use must be less than the allowable maximum power (200W) of
this unit.
3. When the AC port is not in use, turn it off to conserve power.
LED LIGHT
This unit has a built in 3W Ultra bright LED flashlight, which can provide long time illumination for outdoor and
emergency occasions.
Press the flashlight button to switch on the flashlight (as below), and a further single press to switch to
blink/SOS mode, and then press the button again to switch off.
Warning: Do not point directly at anyone’s eyes to avoid any injury due to the strong light.
RECHARGING
Connect the charger plug to the DC Input of the unit to charge it. The power indicators will blink to indicate that
the unit is charging. When the unit is fully charged all power indicators will stop blinking and remain solid. After
the unit is fully charged, remove the charger plug.
Protection Modes:
1. Charge Over-Current Protection: this unit has maximum charge current limitation, so as to prevent excessive
charge current from damaging the battery and circuit components.
2. Charge Over-Voltage Protection: this unit has maximum charge voltage limitation, so as to prevent excessive
charge voltage from damaging the battery or causing a fire.
3. Trickling Charge: if the battery is seriously depleted, it will use small current to charge the unit.
This unit supports 3 ways of recharging (as below). You can use this unit when it’s charging.
1.Charge through AC adapter
Using the included AC adapter(15V/3A), plug the unit into any wall outlet to quickly charge the unit. The fully
charged time is about 6-7 hours. Please remove the AC adapter after the unit is fully charged, so as to ensure
the product safety and extend the life of AC adapter.

2.Charge from your car with a 12V Cigarette Lighter Adapter
Using the included car charger, plug the unit into a 12V cigarette lighter (car port) of your car. To protect your
car battery and avoid car battery power loss, please charge this unit when your car engine is started. Please
remove the power cable after the unit is fully charged.
3.Charge from a Solar Panel
This unit is optimized for improving solar charging efficiency, with MPPT (Maximum Power Point Tracking)
function. This supports a 14V-24V charging voltage and a maximum charging current of 3A, to ensure the
maximum charging effect in limited sunshine.

Notice:
1. The actual charging effect of solar energy is related to local effective sunshine, climate, environment and
other factors. Please equip solar panels according to local conditions.
2. Place the solar panel in the strongest position in direct sunlight and avoid the shadows shielding the solar
panel.
3. If don’t use the unit for an extended time, please disconnect the solar panel from the unit.
PRODUCT NOTES
1. This unit has built-in lithium batteries with no memory effect. Therefore there is no need to activate the
batteries by charging and discharging.
2. In order to extend the life of the unit (lithium battery), please charge it regularly and avoid deep discharge.
3. In a low-temperature environment, the battery activity is reduced, and discharge capacity is reduced
exponentially, please use the unit in an appropriate environment. Charging and discharging can increase the
temperature of the unit to keep battery capacity at its highest.
4. Use this unit in the range of +5℃～+30℃, to obtain the optimal charging capacity.
5. Solar panel is compatible with 14V-22V voltage, and to achieve ideal charging efficiency, we recommend you
to use 16V-18V solar panels.
6. The lifecycle of battery charging and discharging is 1000 times. After 1000 times, the capacity will be
significantly reduced, and will wear out eventually.
MAINTENANCE AND SECURITY
1. Use the unit properly to avoid electric shock.
2. Do not charge the unit with a charger that doesn’t match this product.
3. Keep the unit away from high temperature, high humidity, high salinity and corrosive environments.
4. Do not expose the unit to direct sunlight.
5. Do not dispose of it in fire.
6. Do not place or store the unit together with bulk metal objects.
7. Do not disassemble or reassemble this unit.
8. Do not intentionally knock, impact, pierce or drop this product.
9. Do not store the unit for a long time under power loss.
10. Do not cover the unit with towels, clothing and other items, so as not to affect heat dissipation.
11. Do not connect the unit with a charger for a long time.
12. Children should be supervised to ensure that they do not play with this unit.
13. Please scrap and recycle this unit in accordance with the regulations.
14. This unit is designed for temporary outdoor and emergency use only. It cannot replace normal alternating
current supply.
15. This unit provides a modified sine wave output, when with inductive load such as fan, there may be some
working noise. This is normal.
STORAGE AND TRANSPORTATION
1. The preservation temperature of this unit is -20℃～+50℃, to ensure the safety of product storage, please
keep it in a dry and cool environment.
2. If the unit is not to be used for a long time, please disconnect all cables and store safely.
3. If the unit is to be stored for an extended period, it’s best to charge within 3 months and charge at least once
within 6 months, so as to extend the life of the unit.
4. Please take care when transporting the unit. Do not drop it and do not press it heavily. Ensure that it is
securely restrained in any vehicle.
RECYCLING
This product is made of lead free materials, and it’s difficult to degrade naturally. In the process of degradation,
it will cause a certain pollution to the environment, and produce precious metals and rare metals. To protect

the environment and make good use of natural resources, please return your used electronic products,
batteries and packaging materials to dedicated collection points.
STATEMENT
Our company is the only manufacturer of this product and user manual, and apply for various patents. Without
the permission of our company, no individual or unit may imitate, reproduce or extract without authorization.
Violators will be held liable for the corresponding legal liability.
This user manual will be updated from time to time based on the product version upgrade, unless otherwise
stated.Please refer to our website for any updated versions.
Please use this unit strictly in accordance with this user manual. If any accidents caused by violating indication
requirements, user bear the consequences.