PowerLite MS-6M-360 User manual

Certainty at The Speed of Light
INSTALLATION
MANUAL
INFRARED MOTION
SENSOR
MS-6M-360

MS-6M-360 infrared motion sensor
The sensor has great detection sensitivity via integrated circuitry. It utilizes the infrared energy from
humans asthe control-signal source.
Power Source: 220-240V/AC
Power Frequency: 50/60Hz
Ambient Light: <3-2000LUX (adjustable)
Time Delay: Min.10sec±3sec
Max.15min±2min
Rated Load: Max.2000W
1000W
Detection Range: 360°
Detection Distance: 6m max (<24℃)
Working Temperature: -20~+40℃
Working Humidity: <93%RH
Power Consumption: approx 0.5W
Installation Height: 2.2-4m
Detection Moving Speed: 0.6-1.5m/s
As the detector responds to changes in temperature, avoid the following situations:
•Avoid pointing the detector towards objects with highly reflective surfaces, such as mirrors etc.
•Avoid mounting the detector near heat sources, such as heating vents, airconditioning units, light
etc.
•Avoid pointing the detector towards objects that may move in the wind, such as curtains, tall
plants etc.
Warning. Danger of death through electric shock!
Must be installed by professional electrician.
Disconnect power source.
Cover or shield any adjacent live components.
Ensure device cannot be switched on.
Check power supply isdisconnected.
•Please turn the upper cover anti-clockwise as per the diagram on
the right.
•Connect the power and the load as per the wiring diagram.
•Fix the sensor to the installation surface.
•Placethe cover backonto the sensor, then switch on the power and
test it.
Introduction
Installation
Specifications
Connection
Installation

TEST:
•
•
Adjust the hold time using the time control on
the side of the sensor to 10 seconds.
•Turn LUX control clockwise to the minimum (3). If the ambient light ismore than 3LUX, the
sensor will not be activated. Ifthe ambient light is less than 3LUX (night time), the sensor will be
activated.
Note if testing during daylight, turn the lux control clockwise to the sun setting.
If the lamp is more than 60W,the distance between lamp and sensor should be60cm at least.
•The load does not work:
a. Please check ifthe connection of power source and load is correct.
b. Please check ifthe load is ok.
c. Please check ifthe settings of on the sensor correspond to ambient light.
•The sensitivity ispoor:
a. Please check ifthere is any obstruction in front of the detector that would cause the
sensor not to receive a signal.
b. Please check ifthe ambient temperature is too high.
c. Please check ifthe induction signal source isinthe detection field.
d. Please check ifthe installation height corresponds to the height recommended
in the instruction leaflet.
•The sensor won’t switch off the load automatically:
a. Please check ifthere is continual signal in the detection field.
b. Please check ifthe time delay is set to the maximum position
Rear Cable Entry
Side Cable Entry
Recommended installation Height: 2-4m Detection Distance:Max.6m
Wiring Diagram
Sensor Information
Testing the Sensor
Troubleshooting
Switch on the power; the sensor and its connected lamp will have no signal to start with. After
Warm-up 30sec, the sensor will work. If the sensor receives the induction signal, the lamp will turn
on. When there is no induction signal, the load should stop working within 10sec±3sec and the
lamp would turn off.