Prem-I-Air EH0139 User manual

EH0139
Carpet Dryer
3 Speed settings
Telescopic handle for portability
Page 1

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the
product for future reference.
OPERATION
• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead is rated at 6
Amps or more, and that it is fully unwound
• Tilt the fan to the required angle
• Switch the appliance on at the mains socket.
• Turn the rotary switch to the speed required:
• It is normal for the motor to become warm in normal use.
• Unplug the appliance from the mains when not in use.
PRODUCT SAFETY
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the
appliance
• Do not use in close proximity to gas appliances
• Do not use unless correctly installed.
• Do not cover when in use.
• Do not place the mains lead beneath a carpet or rug.
• Do not use the appliance in locations where paint, petrol or other
flammable liquids are used or stored.
• Do no insert any object into the appliance through the grilles. This may
damage the appliance or result in overheating or electric shock.
• Do not use this appliance in the immediate surroundings of a bath, a
shower or a swimming pool.
• The appliance is fitted with an overload cut-out which will operate if the
motor overheats or is stalled. If this happens, disconnect from the mains
supply immediately, and allow the motor to cool down.
Page 2

PAT TESTING
When used in an office environment, this product must be safety-tested
yearly by a qualified electrician (PAT Tested) in order to comply with the
Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at
least once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the
wiring must be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is
mandatory for new buildings).
OPERATING COSTS
At time of going to press, the average cost of electricity is 11p per unit
(kilowatt-hour). The amount you are being charged will be shown on your
electricity bill. At this cost, the fan will cost 5p per hour to run on the "low
speed" setting, or 9p per hour to run on the "high speed" setting.
MAINTENANCE
Before cleaning, turn the appliance off, and disconnect from the mains
supply. The appliance may then be cleaned using a damp cloth with a
drop of washing-up liquid to remove any dust or dirt from the case. Do no
use stronger detergents or solvents as these may damage the paint
finish.
Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or
and authorised service centre.
If the mains plug needs to be replaced, proceed as
follows:
• Connect the brown wire to the terminal labelled "L".
• Connect the blue wire to the terminal labelled "N".
• Connect the green/yellow wire to the terminal
labelled with the earth symbol or "E".
• Make sure that the cord-grip is positioned correctly (over the outer
sheath of the cable) and it fully tightened.
Fuse
(13A)
Earth
(Green
Yellow)
Neutral
(Blue) Live
(Brown)
Page 3

DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and
disposal is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your
retailer may take the old appliance for disposal.
TECHNICAL SPECIFICATION
Dimensions: 500×440×410 mm
Weight: 14 kg
Power supply: 230V ~
Mains plug fuse: 13 A to BS1362
Power consumption: low speed: 460 W
medium speed: 530 W
high speed: 800 W
Air flow high speed: 2200 m3/h
Operating current: low speed: 2.0 A
medium speed: 2.3 A
high speed: 3.5 A
SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in materials and
workmanship for a period of twelve months.
Should this appliance be operated under conditions other than those
recommended, at voltages other than the voltage indicated on the
appliance, or any attempts made to service or modify the appliance, then
the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This
warranty is in addition to, and does not affect, your statutory rights.
If you have any problems with this product, please call our Help Desk on
[phone]. Prem-i-Air Appliances Ltd.,
Lancots Lane, Sutton,
St. Helens, Merseyside.
WA9 3EX
website: www.prem-i-air.com
Page 4