PREMIER POLYSTEEL 908-D81 User manual

A
Table Top
Leg
Leg Brace
DETAIL A
SCALE 1 : 6
Note that the legs
are on the right side
of the support frame.
Threaded Stud
Assemble the table upside down. Protect the Table top from 1.
scratches by placing cardboard between it and the concrete floor.
Drill out holes in the Table Top, Legs and Leg Brace using a 7/16" 2.
dia. drill bit.
Attach the legs to the Table Top with a bolt, 2 washers & locknut.
Do 3.
not tighten the bolts and locknuts at this time.
Attach the Leg Brace with flat top towards the Table Top. Use a 4.
locknut and washer on each threaded stud.
Do not tighten at this
time.
Set table upright on a level surface and tighten all the hardware. 5.
Make sure that the Table Top is level as you tighten the hardware.
908-D81
SHEET 1 OF 2
SCALE: 1:8
WEIGHT:
REV
DWG. NO.
A
SIZE
TITLE:
5
4
3
2
1
In Accordance to California law: WARNING This product contains a
chemical know to the State of California to cause cancer and birth
defects or other reproductive harm.

27 3/8"
30"
908-D81
SHEET 2 OF 2
SCALE: 1:8
WEIGHT:
REV
DWG. NO.
A
SIZE
TITLE:
5
4
3
2
1