PREMIER POLYSTEEL 938-45D-2 User manual

Part No. Description Qty.
652-017 45deg Contour Seat 3
652-026 45 deg Arc Support Frame
Direct Bury
1
516-058 3/8” X 1-1/2” SS Hex Bolt 18
516-028 3/8” SS Nylock Nut 18
516-023 3/8” SS Washer 36
938-45D-2
1Position the support frame in the desired location and mark ground where holes need to be
drilled.
2Drill plastic out of the mounting holes on the seats and stand using a 7/16” dia. drill bit.
3Fasten the seats to the stand loosely.
4Make sure that the three seats are level with each other and tighten all of the bolts.
5Support the seats and frame at the desired height in the holes.
6Fill holes with concrete and crown the top so that water will run off. Let stand for at least 24
hours before removing supports.
Periodic check of bolt tightness recommended.
723
8
2811
16
181
2
12
In Accordance to California law: WARNING This product contains a chemical know to the State of California
to cause cancer and birth defects or other reproductive harm.

Part No. Description Qty.
652-017 45deg Contour Seat 3
652-036 45 deg Arc Support Frame
Surface Mount
1
516-031 3/8” X 1-3/4” SS Btn Skt Cap Screws 18
516-028 3/8” SS Nylock Nut 18
516-023 3/8” SS Washer 36
938-45D-7
1Position the support frame in the desired location and anchor it to the concrete.
2Drill plastic out of the mounting holes on the seats and stand using a 7/16” dia. drill bit.
3Fasten the seats to the stand loosely.
4Make sure that the three seats are level with each other and tighten all of the bolts.
Periodic check of bolt tightness recommended.
723
8
2811
16
181
2
In Accordance to California law: WARNING This product contains a chemical know to the State of
California to cause cancer and birth defects or other reproductive harm.