PRESONUS STUDIO LIVE RACK EAR User manual

StudioLive Rack Ear Installation Instructions
Step 1:
Step 3:
Step 2:
Step 4:
Step 5:
Using a Philips screwdriver, remove the three screws beneath the decorative
plastic side panel on the right side of your StudioLive. Set these screws aside.
You will need them should you want to reinstall the side panel at some point
in the future.
Gently slide the plastic side panel toward the front of your StudioLive until
you hear a click. Pull the side panel
toward you to remove it.
Once the side panel is removed, you will see three metal clips. Remove the
screw that attaches each of these clips to your StudioLive. Set aside these
screws. You will need them to attach the rack ear to your StudioLive.
It is recommended that you attach the clips back to the decorative side panel
using the screws you removed in Step 1 to store them. Both the clips and
screws are necessary to reattach the side panel.
Remove the four screws at the top.These 5mm screws will be replaced with
slightly longer ones. Set them aside and store them with the side panel.
Using the screws you removed from the metal clips in Step 3, attach the Rack
Ear labeled ‘R’ to your StudioLive. In your Rack Ear installation kit, you will
find four 6mm screws.Thread
these through the four holes
at the top of the Right Rack
Ear and attach them to your
StudioLive.
Repeat these steps to attach the Left Rack Ear to your StudioLive.