Prestigio MultiPad PMP3084B Use and care manual

PMP3084B
FIRMWARE UPDATE INSTRUCTION
(utility ver. 1.23)
This way of FW upgrade/restoration allows force upgrade, even in case of mismatch of the device
article and FW file version. Please mind the original article when performing the update. It could be found
on a back cover of the device as well as on its package box (see pics below)
Model name on a back cover
Model name on a package box
The upgrade procedure contains of 2 stages:
– USB RK282x driver installation (should be installed just once, at 1st connection)
– FW update
DRIVER INSTALLATION
1
Please, unpack the PMP3084B FW update utility you PC.
Make sure the PMP3084B is completely switched off and NOT connected to USB.
2
Press a PAGE DOWN button (#1, marked with
red on a picture)
Keep the button pressed and connect the device
to the PC
Release the PAGE DOWN button

PMP3084B
3
The system will report a new device and offer to
install the driver for this one.
IF there is no NEW DEVICE FOUND notification –
pls check the Device Manager for a new
device(Scan for Hardware Changes could help )
right-click on the RK281X Device, select Update
Driver Software)
4
The set of available drivers could be found in
/281xDriver folder of the FW Update Utility
package.
There are available drivers both for 32 and 64-
bit systems (folders/281xDriver/amd64 and
/281xDriver/x86 respectively. We advise to use
36-bit ones as some compatibility issues were
reported for 64bit drivers.
5 The driver setup procedure is generic for all the Window systems, the screenshots below illustrate
the process.

PMP3084B
FIRMWARE UPDATE
Please refer to MID Business Development Manager for newest FW file for production/rework
operations.
Actual FW for warranty service use is available at
http://service.prestigio.com/TABLET/PMP3084/FIRMWARE/
Please connect the PMP3084B to USB AS
DESCRIBED IN CHAPTER 2 OF DRIVER
INSTALLATION OPERATION: switch off the
PMP3084B, press the Page Down button,
connect USB cable.
Run the FW update utility
.../toolsv1.23/RKAndroidBatchUpgrade.exe

PMP3084B
The respective box at Device Upgrade Area
will have GREEN color.
This mean the device is connected properly
and is ready for FW update.
NOTE:
The possible solutions for the situation that no
GREEN box appears are:
- re-install the RK281x driver,
- connect the device to another USB port
- check the USB cable and replace it if
necessary
Please set the path to the FW file by pressing
the button marked with red. The utility will
recognize the FW version as well as boot loader
version info
Uncheck the checkbox Erase User Section in
order to keep all the user info, data and 3rd party
software.

PMP3084B
Press Upgrade button
The upgrade process starts.
Do not disconnect the USB cable during the
upgrade process
As soon as the FW re-flash process will be over
the box in Device Upgrade Area will be GREY
Log will state that Upgrade is over.
As soon as this operation is over the PER3084B
will restart automatically

PMP3084B
After the restart the device will re-format the
DATA and CACHE partitions, it will take about
3-5 minutes
After the initial touchscreen calibration, locale
selection and setup the update process is
finished