Primex GB7 User manual

STEP 2STEP 1
STEP 4 Removing Gateway from Holder
STEP 3
STEP 2STEP 1 STEP 3
Insert Wall Mount Screw
Locate stud and mark location on wall where
Gateway will be placed and drill included screw.
Insert Gateway into Holder
Place in desired position.
Secure Gateway
Snap second holder on top of Gateway into
place, supporting bottom of bracket with hand.
Release Cavity
Using a at head screwdriver,
place under the release cavity.
Release Cavity
Once in the release cavity, twist the screwdriver.
Repeat placing screwdriver at the top on opposite side.
Remove Cover
Remove top of holder to
access Gateway.
Install Gateway Holder
Secure one holder into slot.
Ax with second screw.
GB7 GATEWAY MOUNTING VIDEO:
Gateway Mounting Bracket (GB7)
P/N 125-1875
PRIMEX
Installation Instructions: On Wall

STEP 1 STEP 2 STEP 3
STEP 6STEP 5STEP 4
Remove Existing Faceplate Install Gateway Holder
Install using faceplate screws
through existing gang box holes.
Insert Gateway into Holder
Place in desired position.
Secure Gateway
Snap second holder on top of Gateway
into place. Attach any required cabling.
Coax Cable
Pull coax cable through the Gateway
holder via cable slots.
Coax Cable
Pull existing coax cable
through gang box.
GB7 GATEWAY MOUNTING VIDEO:
Gateway Mounting Bracket (GB7)
P/N 125-1875
PRIMEX
Installation Instructions: Gang Box