Primus 2243 User manual

AU 2243 PRIMUS ClassicTrail, Stove
INSTRUCTIONS FOR USE
2243
-845BS-08
64997
ID: 845BS-0033
Design and Quality Primus AB Sweden
Tel: [phone]
www.primus.se
IMPORTANT: Read these instructions carefully and
familiarize yourself with the product before
fitting the appliance to the gas cartridge.
Familiarise yourself with the appliance
before connecting it to its gas container.
Review the instructions periodically to
maintain awareness. Retain these instructions
for future reference.
USE OUTDOORS ONLY!
NEVER cover the stove (gas cartridge) with wind
shields, rocks or similar which may cause over
heating and damage the stove and cartridge.
Overheating a gas cartridge by this means is highly
dangerous.
1. INTRODUCTION
1.1 This appliance shall be used exclusively with
Primus Propane/Butane mix cartridges 2206, 2202
and 2207.
1.2 It may be hazardous to attempt to fit other types of
gas cartridges.
1.3 Consumption: 16.0 MJ/h
1.4 Jet Nipple size: 0,37 mm, (731840)
1.5 This appliance complies with
EN521 /
ANSIZ21.72/11.2
2. SAFETY INFORMATION (fig.1)
2.1 Ensure that the appliance seals (1) are in place
and in good condition before fitting gas cartridge.
2.2 The appliance should be used outdoors only.
2.3 The appliance must be operated on a level
surface.
2.4 Ensure that the appliance is operated away from
inflammable materials.
2.5 Always change or fit the gas cartridge in a safe
place, only outside, away from any source of
ignition such as naked flames, pilot lights, electric
fires and away from other people.
2.6 If you have to check the gas soundness of the
appliance, do this outdoors. Do not check for
leaks with a naked flame. Use soapy water only,
for example.
2.7 Never use an appliance with damaged or worn
seals and never use a leaking, damaged or
malfunctioning appliance.
2.8 Never leave the appliance unattended
while in operation.
2.9 Do not allow pans to boil dry.
2.10 This appliance shall only be used with a 80%
butane/20% propane mix cartridge certified to
EN417.
2.11 USE ONLY IN WELL VENTILATED AREAS -
CARBON MONOXIDE HAZARD-USING THIS
APPLIANCE IN AN ENCLOSED SPACE MAY
CAUSE DEATH. DO NOT USE IN CARAVANS,
TENTS, MARINE CRAFT, CARS, MOBILE
HOMES OR SIMILAR LOCATIONS.
OUTDOOR USE ONLY.
2.12 Ensure this appliance is operated away from
inflammable materials, (minimum clearance
500 mm).
2.13 Do not use this appliance if it is leaking,
damaged or does not operate properly.
2.14 Gas containers shall be changed in a well
ventilated location, preferably outside away
from people and any sources of ignition, such
as naked flames, pilot flames, electric heaters/
equipment.
2.15 If there is a leak from your appliance, (smell of
gas), and you cannot stop the gas flow, remove
the appliance to a well ventilated location away
from any ignition source. Check for leaks using
soapy water. Do not try to detect leaks with a
flame.
2.16 This appliance must only be serviced by an
authorised person.
3 HANDLING THE APPLIANCE
3.1 Be careful not to touch hot parts of the
appliance during, or after use.
3.2 Storage: Always unscrew the cartridge from
the appliance when not in use. Store them in a
safe dry place away from heat.
3.3 Do not misuse the appliance, or use it for
anything for which it has not been designed.
3.4 Handle the appliance with care. Do not drop it.
4. ASSEMBLING THE APPLIANCE (fig.2)
4.1 Ensure that the control knob (2) is turned off
(turned fully clockwise).
4.2 Keep the cartridge (3) upright when fitting it to
the valve.
4.3 Place the valve squarely on top of the cartridge
(as shown in fig .2).
4.4 Gently screw the cartridge into the valve
until it meets the O-ring of the valve. Be
careful not to fit the cartridge cross
threaded. Screw hand tight only. Do
not overtighten or you will damage the
cartridge valve.
4.5 Ensure that a complete gas seal has been
made. If you have to check the gas soundness
of the appliance, do this outdoors. Do not
check for leaks with a naked flame. Use warm
soapy water only, applied to the joints and
connections of the appliance. Any leakage will
show up as bubbles around the leakage area.
If you are in doubt or you can hear or smell
gas, do not attempt to light the appliance.
Unscrew the cartridge and contact your local
dealer.
4.6 Make sure the burner is screwed down tightly.
The stove is now ready for use.
5. OPERATING THE APPLIANCE
5.1 Always operate the appliance on firm level of
surface.
5.2 Turn the knob anticlockwise (2) and light the
burner (4) immediately.
5.3 Adjust the size of the flame by turning the
control knob (2).
5.4 After lighting, operate the appliance upright
and do not move it around. Flaring may occur
if the appliance has not fully warmed, or if it is
moved carelessly.
5.5 After use, ensure that the valve is fully shut
(control knob turned fully clockwise).
5.6 The »-« symbol on the control knob reduces the
gas flow and the »+« symbol increase the gas
flow.
5.7 To check if the gas canister is empty, disconnect
from the appliance and shake from side to side.
If there is no sound or movement of liquid, the
canister is empty.
6. CHANGING THE CARTRIDGE
6.1 Shut the valve fully. Be sure the flame is
extinguished and no other flame is nearby.
Take the unit outdoors away from other
people. Unscrew the cartridge from the valve
and replace the appliance sealing O-ring if
it is cracked or worn. Avoid cross threading
by puting the valve onto the cartridge screw
thread squarely and screw on hand tight only,
as described in section 4.
7. MAINTENANCE
7.1 If gas pressure drops or the gas will not light,
check if there is gas left in the cartridge (3). If
so, the Jet Nipple (10) might be blocked.
Cleaning the Jet Nipple
7.2 Fully turn off the control knob (2) and unscrew
the cartridge (3).
7.3 Unscrew the burner (4).
Fig 1
Fig 3
PRIMUS
Mimer Stove
Fig 2
1
3
4
10
2

FOR YOUR SAFETY
If you smell gas
1. Do not attempt to light appliance.
2. Extinguish any open ame.
3. Disconnect from fuel supply.
FOR YOUR SAFETY
Do not store or use gasoline or other liquids with
ammable vapours in the vicinity of this or any other
appliance.
CARBON MONOXIDE HAZARD
This appliance can produce carbon
monoxide which has no odor.
Using it in an enclosed space can kill
you.
Never use this appliance in an enclosed
space such as a camper, tent, car or
home.
DANGER
Keep stove area clear and free from
combustible materials, gasoline and other
ammable vapors and liquids.
!
See too that no obstruction of combustion or
ventilation occur.
!
See too that the ame on the appliance is
steady. The ame shall always leave the
stove straight upwards.
Note! Wind may press the ame down under
the burner, if that happens stop the stove
immediately and move it to a wind protected
area.
!
When the stove is in storage, the gas
canister has to be disconnected.
!
7.4 Unscrew the Jet Nipple (10) using a 6 mm
spanner.
7.5 Clean out the Jet Nipple by blowing through the
tiny hole at the front. Do not use an incorrect
size picker or any type of pin etc. to clean the
blockage or you may damage the hole and make
the appliance unsafe.
7.6 Re-fit the Jet Nipple and screw it tightly to ensure
a gas seal. Re-fit the cartridge by following the
description in section 4. For extra safety, check
the joint with warm soapy water. If bubbles
appear, the joint is not tight enough.
7.7 Rescrew the burner tightly.
8. ROUTINE SERVICE AND MAINTENANCE
8.1 Always ensure that the sealing O-ring (1) is in
place and in good condition. Inspect it every time
you assemble the appliance. If it is damaged or
worn, replace it.
8.2 New sealing O-rings are available from your local
dealer.
9. SERVICE AND REPAIR
9.1 If you cannot rectify any fault by following these
instructions, return the appliance to your local
retailer.
9.2 Never attempt any other maintenance or repair.
9.3 Never modify the appliance. This may cause the
appliance to become unsafe.
10. SPARES AND ACCESSORIES
10.1 Use only Primus brand spares and accessories.
Be careful when fitting spares and accessories.
Avoid touching hot parts.
10.2 Replacement Cartridges: Use only Primus 2206,
2202, 2207 Propane/Butane mix gas cartridges
with this appliance.
10.3 Spares
731840 Jet Nipple
732440 O-ring
An optional Piezo Igniter 720120 and Cartridge
Support 721171 (for extra stability) are available.
10.4 In the event of difficulties in obtaining spare parts
or accessories, consult the distributor in your
country. Visit www.primus.se