Principal LED PL-CT-A02-A User manual

RGB Controller
Manual

PANEL & INTERFACE SPECIFICATIONS
Turn o/on LED in any state
Touch for selecting 18 change modes before and after.
Touch the color wheel to get what the color you desire.
Static modes for brightness increasing or decreasing.
Dynamic modes for speed accelaterating or decelerating.
Voltage of power input port: 12V/24V
Power output for connecting LEDs
Indicative lgiht to show the power and signal reciever state
This remote uses AAA batteries (1.5V). First, open the cover of the battery; load 3 AAA batteries correctly as per the positive and negative instructions in the battery
pack. If the indicator lights on the remote controller ash regularly without touch, please note the battery should be changed.
REMOTE CONTROLLER BATTERY INSTALLATION
When the user does not touch the remote controller for 20 seconds, the remote controller will automatically enter the lower power sleep mode to save standby power
consumption and extend battery life. When the user needs to re-use the controller, only touch any key on the touch panel (not the color wheel) to wake up the remote
controller for normal use.
LOW POWER CONSUMPTION AND AWAKENING
MODE TABLE
Number Mode Remark Number Mode Remark
1 Static Red
Adjustable brightness
10 3-Color Gradient
Adjustable brightness
and speed
2 Static Green 11 3-Color Smooth
3 Static Blue 12 7-Color Gradient
4Static Yellow 13 7-Color Smooth
5 Static Purple 14 3-Color Flicker
6 Static Cyan 15 7-Color Flicker
7Static White 16 3-Color Flash
8 3-Color Jump
Adjustable brightness
and speed
17 7-Color Flash
9 7-Color Jump 18 Automatic

WIRING DIAGRAM
POWER AMPLIFIER FIGURE

PRODUCT DIMENSIONS
CAUTION
1. Please install products with help of a professional electrician.
2. This product is not waterproof. Please put into water-proof tank if it will be used outdoors.
3. Make sure to mount this unit in an area with proper ventilation to ensure the tting temperature.
4. Do not install this controller during a lightening storm; it givers o intense magnetic and high voltage elds.
5. Check if the voltage and power adapter suit the controller and LEDs.
6. Please make sure all of the wires can suciently load the LEDs to avoid an accident.
7. Make sure all of the wires are connect correctly before switching the power on.
8. Do not repair or maintain privately, if you have any questions please contact our engineers at 325-227-4577.
RELATED PRODUCTS
Product Part Number
RGB Amplier/Repeater PL-GL-CT-B (P-A318)
www.p-led.com
[phone]
3490 Venture Drive, San Angelo, Texas 76905
[email protected]