Pro DVX APPC-15XP User manual

Quick start
guide
The information in this document is subject to change without notice. © 2023 ProDVX Europe B.V. All rights reserved.
Please check the website or scan the QR-code for more product information.
www.prodvx.com/support
APPC 15XP
-

This package contains:
How to start:
Quick connection settings
Panel PC Quick start guide
*Please note that it is prefered not to use power
tools to attach the device to the mount or stand.
Step 1: Take contents out of the box, make sure all components are present.
Step 2: Install wall/glass mount or desk stand, check designated mount/stand manual for instructions.
Step 3: Connect to Internet through Wi-Fi or PoE+.
Step 4: If applicable, install and configure preferred application.
Step 1: Plug in PoE+ cable or power adapter to turn on display. If using PoE+ for both power and data, this was the
final step. If connection to Wi-Fi is preferred, swipe up in the home menu to arrive in the app drawer. Once there,
select Settings.
Step 2: In the settings menu, go to Network & internet, located at the top of the menu.
Step 3: In the Network & internet menu, select Wi-Fi.
Step 4: Turn on Wi-Fi and select desired Wi-Fi network to connect to internet.
Optional accessories
Landscape Barcode scanner NFC module Camera
Portrait
Tools necessary
but not included
Caution:
Please note this product contains a battery. Please return the product to a certified
repair center for proper replacement of the battery; Disposal of a battery can be
dangerous.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area can cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Europe/UK – EU/UK Declaration of Conformity
This device complies with the essential requirements of the Radio Equipment Directive
(2014/53/EU). The following test methods have been applied in order to prove
presumption of conformity with the essential requirements of the Radio Equipment
Directive This equipment is compliant with Class A of EN55032. In a residential environ-
ment this equipment may cause radio interference.
Correct Disposal of this product.
This marking indicates that this product should not be disposed with other
(household) waste. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the return and collection
systems or contact the reseller where the product was purchased. They can take this
product for environmental safe recycling.
“FCC & CE RF Radiation Exposure Statement Caution: To maintain compliance with
the FCC & CE’s RF exposure guidelines, place the product at least 20cm from near by
persons.”
The suitable temperature for the ProDVX Display and accessories is 0°C-45°C.
APPC 15XP Quick start guide
-
Backside
Pogo pin connector
Speaker Speaker
VESA 100 mount
Screw spec: M4*4 mm
Bottom view
USB 2.0 port
USB 3.0 port
COM port 1
COM port 2
Mini HDMI out
USB-C port
GPIO port
S/PDIF port
Audio port 3.5 mm
12 V DC-in
On / o switch
LAN port
USB 2.0 port
Volume
+ and -
Scroll
up / down
Back / home
button
USB 2.0 port
SD-card slot with USB 2.0 port