Pro-Ject Audio Systems Juke Box Series User manual

Please read before unpacking!
Setup Guide
Juke Box

Setup Guide for
Juke Box E & S2

- Make sure you have enough space to unpack your turntable.
Get started:
- Make sure to unpack it in a clean enviroment.
- Do not throw packaging away.
Important for warranty!
More information about the product in the manual.

a) Stylus pressure gauge
b) Batteries for remote control
c) Drive Belt
d) Fabric gloves
e) Adapter for 7“singles / allen key for counterweight setting
f) Weight for ultra light cartridges
g) Bluetooth antenna
h) Power cable (power supply on step )
i) Remote control
1Open the carton and unpack all items from ac-
cessory bag.
5

a) b)
c) d)
e)
f) g)
h) i)

2Remove dust cover carton from the box.

3Carefully remove the turntable protection insert.

4Lift the wrapped turntable out of the box.

5Unpack the power supply.

6Carefully remove the protection covering.
Tonearm is fragile!

7Remove the platter protection.
<

8Put the drive belt on the pulley and platter.
Important: Make sure to have clean hands when touching
the belt. Dirt on the belt can cause it to slip.
Start with the pulley!
Small pulley- 33 RPM
Big pulley - 45 RPM

9Install the Bluetooth antenna.

Unpack dust cover and put it on the turntable.
10

How to correctly position your speakers.
11
For enjoying a perfect stereo image:
If the speakers are two meters apart
from each other, the listener should sit at a
maximum position of three meters, but no futher.
For longer distances please use this 2:3 rule.
<
<
Equilateral triangle
< <
Speakers should be
turned towards
the listener
Tweeter level
80-120 cm

12
Power cable
Speaker cables
left and right
speaker channel
Plug speaker cables into the turntable / connect the
power cable.
Please note: „L“ out is going to the speaker that you see on your left when you’re looking
at your system. „R“ to the right speaker.

Remove tonearm twist tie.
13

Turning on the Juke Box.
14
To switch on from
standby or to
standby (amplier)
Switching ON and
OFF
(turntable motor)

Control of the unit using the knob on the front.
15
Standby
Press the knob for 3 seconds to turn the unit on.
Input selector
Briey press the knob to switch between Bluetooth > Turntable > Line In
Volume
Adjust volume by turning the knob.
Selected input and
volume is indicated
on the display

Remove the needle protection cover.
16
Beware of breaking
the needle!