Pro-Ject Audio Systems X2 User manual

1Unpack all items from accessory box. 2Remove dust cover carton from the box. 4
Lift the wrapped turntable out of the box.
5Unpack the power supply. 7Put the drive belt on the pulley
& sub-platter. 8Put the platter on the turntable.
9Remove tonearm twist tie. 11 Put the counterweight in place. 12
Lower the tonearm lift and place the
tonarm between platter & armrest.
13 Balance the tonearm by turning the
counterweight until it stays level.
14 Turn the front scale of the counterweight
to Zero without moving the weight itself.
15 Turn the counterweight counterclockwise
until the scale reads roughly 18.
16
Put the needle protection cover back
on the cartridge.
17
counterweight
Connect it E
RCA cable
single adapter
& Allen key
drive belt
Antiskating
Weight
3Unpack the acrylic platter
and subplatter.
6Carefully remove the protection covering.
Remove the needle protection cover.
Put the loop of the Antiskating Weight in
the second groove on the tonearm post.
18 Unpack Dust Cover and put it on
the turntable.
19 Connect to your sound system and you
are ready to enjoy your records!
20
Small pulley- 33/45 RPM
Big pulley - 78 RPM (round belt)
0°
>
>
www.project-audio.com/en/products/x2
Technical Data
Speed
Principle
Speed cariance
Wow & utter
Platter
Main bearing
Tonearm
33, 45, 78 (electronic speed change)
belt drive
33: +/-0,25%; 45: +/-0,20%
33: +/-0,12%; 45: +/-0,10%
30mm thick acryl, 2 kg heavy acryl
Stainless steel
9” carbon/aluminium sandwich tonearm
Eective arm length
Overhang
Eective tonearm mass
Tracking force range
Power consumption
Dimensions
Weight
9“/230 mm
18 mm
13,5 g
0 - 30mN
4.5 W max / 0.3 W standby
460 x 150 x 340 mm (WxHxD) lid closed
10 kg net
>
X2 Setup Guide
Please read before unpacking.
Getting started:
Make sure you have enough space to unpack your turntable.
Always unpack and setup in a clean enviroment
Important for warranty: Do not throw packaging away.
Unpack the Antiskating stub and screw it
into the pre-drilled hole.
10
>
Lower the tonearm with the lift.
Plug in Connect it E
RCA Cable.
Plug in the power
supply.