PRO SIGNAL PSG03928 User manual

4 Way Stereo Headphone Distribution Amplier
PSG03928
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
When using electrical appliances basic safety precautions should always be followed.
• To prevent re or shock hazard, do not expose this product to rain or moisture.
• Only use the PSU supplied or one of identical specication.
• Beware that listening for long periods and at high volume levels may cause fatigue
and hearing damage.

CONNECTIONS
• A compact solution to connect up to 4 headphones taking the feed from either a
3.5mm stereo or line level phono output with pass through.
• Connect analogue source equipment to the 3.5mm stereo jack or the L and R RCA
Phono, as required using suitable cables.
NOTE: only one input must be used - do not connect to both simultaneously.
• If a pass through signal is required, connect the device to the 3.5mm stereo output
jack or the L and R RCA Phono output.
• Connect up to 4 sets of headphones to the output jack sockets on the rear panel.
• Connect the PSU 12V output to the power in socket and plug the PSU into the
mains supply and turn on the power. The red LED will illuminate.
OVERVIEW

• When the source equipment is outputting a signal it can be heard through the
headphones.
• Adjust the volume for each set using the rotary controls on the front panel.
SPECIFICATIONS
OPERATION
Output Power: 105mW (rms) per channel
THD+N: 0.05% (@ RL = 16R, F = 1kHz)
Power Supply: 12V DC, 2A PSU
Connector 3.5mm (⅛”) stereo jack
Min. Load Resistance: 18R
Dimensions (W x D x H) 185 x 85 x 31mm
CLEANING & MAINTENANCE
• Clean the outside casing with a soft cloth lightly moistened with a mild detergent
• Never use any abrasive or solvents.

INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL & ELECTRONIC
EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic Equipment (WEEE).
Any WEEE marked products must not be mixed with general household waste, but kept separate for the treatment,
recovery and recycling of the materials used. Contact your local authority for details of recycling schemes in your area.
Made in Taiwan
PR2 9PP
Man Rev 1.0