PRO SIGNAL PSG08482 User manual
1
Model: PSG08482
Digital Indoor/Outdoor Thermometer
Please read these instructions carefully before use and retain for future reference.
• Please operate according to this manual, otherwise the protection provided by the
device will be impaired or fail.
• Do not use the thermometer if it operates abnormally.
• Before replacing the battery, turn off the thermometer.
• Replace a full set of batteries at one time.
• Remove dead batteries from the thermometer or if it is not going to be used for a
long time.
• Never mix old and new batteries together, or different types of batteries.
• Never dispose of batteries in a re, or attempt to recharge ordinary batteries.
• Remember to keep small button cell and AAA batteries away from small children as
they can easily be swallowed.
• To prolong battery life turn off the thermometer after use.
IMPORTANT SAFETY INFORMATION
2
WHAT’S INCLUDED
• Indoor/outdoor thermometer
• Instruction manual
OPERATION FUNCTION
• Before use remove the battery door and remove the plastic tag isolating the battery.
• Press °C/°F button button to change between °C and °F.
• Press and hold Alert/Set button for 1 second, then you can set the temperature point
A in the OUT temperature window by °C/°F.
• Press Alert/Set button again, to set temperature point B in the IN temperature window
by °C/°F Button.
• Press Alert/Set Button again to return to normal display.
• The alarm will sound when either indoor and outdoor temperature value is higher
than A or lower than B.
• Press Max/Min button to display the max & min temperature values recorded for both
indoor and outdoor temperature.
• Repeat press the button again to switch from max value to min value to current value.
• Press the reset button to erase the stored maximum & minimum temperature values
and set alert temperature value.
SPECIFICATIONS
Indoor temperature range -20 to 50°C (-4 to 122°F)
Outdoor temperature range -50 to 70°C (-58 to 158°F)
Temperature accuracy 0 to 50°C (±1°C), <0°C or >50°C (±2°C)
Temperature resoluon 0.1°C
Sensor wire length 1.8m
Unit size 110x70x20mm (4.3x2.75x0.78”)
Display size 30x40mm (1.18x1.57”)
Digit height 12mm (0.5”)
Power source 1 x AAA baery
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT
These symbols indicate that separate collection of Waste Electrical and Electronic Equipment
(WEEE) or waste batteries is required. Do not dispose of these items with general household
waste. Separate for the treatment, recovery and recycling of the materials used. Waste batteries
can be returned to any waste battery recycling point which are provided by most battery retailers.
Contact your local authority for details of the battery and WEEE recycling schemes available in
your area.
Made in China. PR2 9PP
PO Box 13362 Dublin 2
Man Rev 1.0
Table of contents
