Projecta SPP40K, User manual

WARNING
sFor installations with lead acid batteries, avoid sparks or flames near the batteries and
always use proper eye protection.
sGiven sufficient light, solar panels always generate energy even when they are disconnected.
Accidental ‘shorting’ of the terminals or wiring can result in sparks causing personal injury
or a fire hazard.
sDo not scratch or bend solar panels.
sDo not disassemble the solar panel frame.
sWhen mounting solar panels at a height adhere to all relevant safety regulations.
sFor fixed installations ground the frame of the solar panel’s to reduce lightning hazard.
sDo not walk on modules.
sDo not attempt to increase module output by concentrating light on its surface with mirrors.
sBe sure to use components (cables, fuses, etc) greater than 25% of solar panel’s maximum
currentratings.
sWhen storing the Solar panel kit not do pack heavy items on top the Solar panel and bag.
FEATURES
Built in Solar Controller
Maintains your battery in a fully charged state while protecting it from over charge and solar discharge.
LED features
GREEN LED: Indicates fully charged
YELLOW LED: Indicates charging
Compact and Powerful
Polycrystalline solar panels are manufactured from a solar cell that is cast from silicon. These cells are more
efficient at producing power than an amorphous panels, so the size of the panel is smaller yet produces
greater output power.
Heavy Duty Frame
Corrosion resistant frames are constructed to withstand wind speeds in excess of 130 km/h in typical ground
mounted applications. The frames are clear anodized and the inner corner connection has a strong mechanical
resistance to weather.
1
SOLAR PANEL KITS
P/No. SPP40K, SPP60K, SPP80K, SPP120K
SPP40K-120K Ins ruc ion Manual_Layou 1 24/01/12 2:00 PM Page 1

2
Tempered Low Iron Glass
Clear encapsulated insulation enhances solar cell performance and provides proven weather protection,
Tempered low iron glass provides both better impact resistance and better light transmission, allowing the
generation of more electricity by reducing the quantity of light that is reflected away from the module.
Convenient Carry bag
This durable padded bag protects your solar panel during storage and transportation.
Carry handle & Safety loop
It is easy to carry the solar panels whilst out of the bag with the carry handle and using the safety loop to
keep the solar panels closed shut.
SPECIFICATIONS
P/No. SPP40K SPP60K SPP80K SPP120K
TYPE POLYCRYSTALLINE
RATED POWER 40W 60W 80W 120W
OPEN CIRCUIT VOLTAGE 17.5V
SHORT CIRCUIT CURRENT 2500mA 3760mA 5000mA 7520mA
PEAK POWER VOLTAGE 17.5V
PEAK POWER CURRENT 2280mA 3430mA 4560mA 6860mA
TEST CONDITIONS 1000W/m2, 25˚C
FUSE 10A10A15A15A
BATTERY Battery Battery Battery Clamps, Battery Clamps,
CONNECTIONS Clamps Clamps Merit Plug (20A), Merit Plug (20A),
Anderson Plug Anderson Plug
(50A) (50A)
SOLAR CHARGE CONTROLLER
TYPE AUTOMATIC
INPUT 12V SOLAR PANELS
MAXIMUM INPUT 25V
BATTERY 12V
CUT OUT 14.4V
CUT IN 13.3V
START 9V
APPROVALS EMC
BATTERY SIZES 250–500CCA 250–650CCA 250–900CCA 250–1200CCA
250–550MCA 300–700MCA 300–1000MCA300–1500MCA
20–70Ah 20–100Ah20–140Ah20–200Ah
5 meter fused lead with battery clamps
5 meter battery leads are connected to the solar panels with battery clamps and fuse, so all you have to do
is connect to the battery.
Fold away support leg
The convenient support legs fold out from the rear to allow easy mounting on flat ground. The legs place
the panels at an optimum angle for maximum performance.
t
Although the panel will function in the horizontal position, for best performance tilt the
p
If the two LED’s are oscillating on
a
F
F
M
W
SPP40K-120K Ins ruc ion Manual_Layou 1 24/01/12 2:00 PM Page 2

C
3
STEP 3 Secure the solar panel to the ground
Insert the four pegs into the ground to secure
the solar panel from falling over.
Two pegs in the body and one in each leg.
INSTALLATION & CONNECTION
STEP 1 Locate the panel in the best position.
Locate the panel in a position where it is exposed to the sun for the majority of the day. For Best results use a
northern orientation. Although the panel will function in the horizontal position, for best performance tilt the
panel directly facing the sun.
STEP 2 Connect to the battery
Connect the 5 meter lead to the battery, Red clamp to the positive (+)
terminal and Black clamp to the negative (-) terminal.
The solar panel will now be charging the battery. The charging (yellow) LED
or fully charged (green) LED will be on. If the two LED’s are oscillating on
and off this means the battery is just about fully charged.
SPP80K shown
MAINTENANCE
Periodically inspect the electrical and mechanical
connections. Make sure they are all tight and free
from corrosion. If necessary clean the surface
of the solar panels with a soft dump cloth. Mild
detergent can also be used. Any dirt or residue
on the glass may effect performance.
FREQUENTLY ASKED QUESTIONS
Q. Can the solar panel be mounted on a flat roof or wall?
A. Yes. It is fine to mount the panel on a horizontal surface such as a roof or on a vertical surface like a
wall as long as the panel receives full sun for a reasonable period of the day. You will however gain better
performance if the panel is tilted toward the sun and faced in a northerly direction, since this enables the
maximum amount of solar energy to reach the panel.
Q. What current output can I expect?
A. The current output (mA) of the solar panel is based mostly on the available solar energy (sun rays). The
current ratings (Peak Power) given in the specifications table are based on the ‘ideal’ sunlight conditions. In
reality this may be achieved only on a very bright sunny day. The normal current output will therefore be a
little lower. If the panel is shaded or if it is a very hot day the output will decrease further.
Q. Will it charge my flat battery & how long will it take?
A. The SPP80K will charge a flat battery (above 9V) 250-650CCA (Automotive) with a charge time of 8-35Hrs.
Q. I am going on a 4WD trip, will 80 Watts be enough?
A. It really comes down to how many appliances are drawing power from your battery.
For example:
Most people when they go away would run a Fridge, and a couple of lights to cook with etc.
We need to work out how much power would be used in a day.
SPP40K-120K Ins ruc ion Manual_Layou 1 24/01/12 2:00 PM Page 3

Energy consumption per day
Appliance Current use/hour (Ah) Total time of use/day (Hours) Total Current per day (Amps)
Fridge 1.5 24 36
3 Lights 3 3 9
Grand Total 45
If we say we get around 10 hours of solar energy from the panels per day (for summer months). We can then
calculate what size and how many panels we need.
45 amps ÷ 10 hours = 4.5 Amps per hour
So the SPP80K solar panel kit produce 4.6 Amps an hour, this should be more than enough. You might find
that during cloudy weather you will have to charge the battery by running your car for half an hour every
second or third day.
WARRANTY STATEMENT
Applicable only to product sold in Australia
Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic., telephone [phone],
fax [phone], warrants that all products described in its current catalogue (save and except for all bulbs
and lenses whether made of glass or some other substance) will under normal use and service be free of failures
in material and workmanship for a period of one (1) year (unless this period has been extended as indicated
elsewhere) from the date of the original purchase by the consumer as marked on the invoice. This warranty
does not cover ordinary wear and tear, abuse, alteration of products or damage caused by the consumer.
Projecta solar panels are covered by a 1 year warranty for materials and workmanship and a 20 year warranty
for at least 80% power output.
To make a warranty claim the consumer must deliver the product at their cost to the original place of purchase
or to any other place which may be nominated by either BWI or the retailer from where the product was bought
in order that a warranty assessment may be performed. The consumer must also deliver the original invoice
evidencing the date and place of purchase together with an explanation in writing as to the nature of the claim.
In the event that the claim is determined to be for a minor failure of the product then BWI reserves the right to
repair or replace it at its discretion. In the event that a major failure is determined the consumer will be entitled
to a replacement or a refund as well as compensation for any other reasonably foreseeable loss or damage.
This warranty is in addition to any other rights or remedies that the consumer may have under State or Federal
legislation.
IMPORTANT NOTE
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Distributed by
AUSTRALIA
Brown & Watson International Pty Ltd
Knoxfield, Victoria 3180
Telephone [phone]
Facsimile [phone]
National Toll Free 1800 113 443
IS043 Issue 3 20.01.12
NEW ZEALAND
Narva New Zealand Ltd
22–24 Olive Road
PO Box 12556 Penrose
Auckland, New Zealand
Telephone [phone]
Facsimile [phone]
SPP40K-120K Ins ruc ion Manual_Layou 1 24/01/12 2:00 PM Page 4