ProLights LUMIPARIRCH User manual

Controller Remoto » LUMIPARIRCH Manuale Utente
ATTENZIONE! Prima di eettuare qualsiasi operazione con l’unità, leggere con attenzione questo manuale e conservarlo accuratamente per
riferimenti futuri. Contiene informazioni importanti riguardo l’installazione, l’uso e la manutenzione dell’unità.
Al ne di migliorare la qualità dei prodotti, la Music&Lights S.r.l. si riserva la facoltà di modicare, in qualunque momento e senza preavviso, le speciche menzionate nel presente
manuale di istruzioni. Tutte le revisioni e gli aggiornamenti sono disponibili nella sezione 'Manuali' sul sito www.musiclights.it
Per qualsiasi necessità si prega di contattare il nostro ucio tecnico: tel. +39 0771 72190 fax +39 0771 721955 - [email protected]
Rev.01 - 09/16 ©2016 Music & Lights S.r.l. - Italy - www.musiclights.it
IT
Avvertenze generali
• Evitare che nell’unità penetrino liquidi inammabili, acqua o oggetti
metallici. • Non smontare e non apportare modiche all’unità. • Tutti gli
interventi devono essere sempre e solo eettuati da personale tecnico
qualicato. Rivolgersi al più vicino centro di assistenza tecnica autorizzato.
• Con le batterie inserite, il dispositivo se non utilizzato per un lungo
periodo, può essere danneggiato dalla fuoriuscita del liquido della batteria.
• Se si desidera eliminare il dispositivo denitivamente, consegnarlo per lo
smaltimento ad un’istituzione locale per il riciclaggio.
Descrizione e speciche tecniche
Controller remoto ad infrarossi per la gestione dei proiettori.
• Accesso istantaneo in remoto a tutte le modalità di funzionamento of-
ferte
• Interfaccia user-friendly per rendere l’utilizzo pratico ed accessibile a tutti
• Modalità Automatica: programmi automatici preimpostati con regola-
zione velocità
• Modalità Sound: attivazione musicale tramite microfono interno, con-
trollo sensibilità
• Controllo Manuale: Selezione colori con macro preimpostate, dimmer e
frequenza strobo
• Raggio di azione: no a 9mt
• Alimentazione: batteria al litio 3V (CR2025)
• Peso: 20g
• Dimensioni: 100x47x7mm
Funzionamento LumiParIRC (telecomando a raggi infrarossi)
NOTA - Assicurarsi di puntare il telecomando direttamente verso il ricevi-
tore dell’unità.
Modalità Automatica
La modalità Automatica consente di eseguire i programmi automatici
dell’unità.
Per passare in modalità Automatica:
1. Premere AUTO sul telecomando.
2. Premere + oppure - per scegliere i diversi programmi automatici.
Per regolare la velocità del programma automatico:
1. Premere SPEED sul telecomando.
2. Premere %.
3. Premere + oppure – per aumentare o diminuire la velocità del program-
ma.
Modalità Sound Active
La modalità Sound Active abilita l’unità per il funzionamento a tempo di
musica.
Per attivare la modalità Sound Active:
1. Premere SOUND sul telecomando.
Per regolare la sensibilità sonora in modalità Sound Active:
1. Premere SENSITIVITY sul telecomando.
2. Premere %.
3. Premere + oppure - per aumentare o diminuire la sensibilità sonora.
Controllo manuale del colore
Per scegliere un colore specico con il telecomando:
1. Premere MANUAL sul telecomando.
2. Premere un numero da 0 a 9 per scegliere il colore.
Per controllare manualmente la percentuale di colore:
1. Premere MANUAL sul telecomando.
2. Premere R, G, B, A, UV, W per scegliere il colore.
3. Premere + oppure - per aumentare o diminuire la percentuale di cia-
scun colore.
Operazioni varie
Per regolare la velocità di lampeggio stroboscopico del programma:
1. Premere STROBE sul telecomando.
2. Premere + oppure - per aumentare o diminuire la velocità di lampeggio.
3. Premere di nuovo STROBE per disattivare il lampeggio.
Per modicare l’eetto di commutazione del programma:
• Premere FADE/SNAP sul telecomando.
• Fade cambia lentamente l’eetto. Snap cambia rapidamente l’eetto.
Per oscurare le luci:
• Premere BLACK OUT sul telecomando.
• Verranno spente tutte le luci no alla successiva pressione del pulsante.
NOTA - Il telecomando non risponde ad alcun input quando è attivo il Black
Out. Se il telecomando non risponde quando viene premuto un pulsante,
provare a premere Black Out; probabilmente il BLACK OUT era stato attiva-
to involontariamente.
Fig.1
IRC REMOTE
BLACK
OUT AUTO
STROBE SPEED
SOUND
SENSI-
TIVITY
%MANUAL FADE
SNAP
RG B
+0
123
456
7 8 9
AUV W

User Manual
Remote controller » LUMIPARIRCH
WARNING! Before carrying out any operations with the unit, carefully read this instruction manual and keep it with cure for future
reference. It contains important information about the installation, usage and maintenance of the unit.
In order to improve the quality of products, Music&Lights S.r.l. reserves the right to modify the characteristics stated in this instruction manual at any time and without prior notice.
All revisions and updates are available in the ‘manuals’ section on site www.musiclights.it
For further information, please contact our Service Center: tel. +39 0771 72190 fax +39 0771 721955 - service@musiclights.it
Rev.01 - 09/16 ©2016 Music & Lights S.r.l. - Italy - www.musiclights.it
EN
LumiParIRC (Infrared Remote Control) Operation
NOTE - Make sure to point the controller directly at the receiver on the
product.
Automatic Mode
Automatic Mode will enable you to run the automatic programs on the
product.
To turn on Automatic Mode:
1. Press AUTO on the controller.
2. Press + or – to choose between the dierent auto programs.
To adjust the speed of the automatic program:
1. Press SPEED on the controller.
2. Press %.
3. Press + or – to either increase or decrease the speed of the program.
Sound Active Mode
Sound Active Mode will enable the product to respond to the music.
To turn on Sound Active mode:
1. Press SOUND on the controller.
To adjust sound sensitivity in Sound Active mode:
1. Press SENSITIVITY on the controller.
2. Press %.
3. Press + or – to either increase or decrease sound sensitivity.
Manual Color Control
To choose a specic color with the controller:
1. Press MANUAL on the controller.
2. Press any number between 0-9 to choose your color.
To manually control the color percentage:
1. Press MANUAL on the controller.
2. Press R, G, B, A, UV, W to choose your color.
3. Press + or – to increase or decrease the percentage of each color.
Miscellaneous Operation
To adjust the strobe rate of the program:
1. Press STROBE on the controller.
2. Press + or – to increase or decrease the strobe rate.
3. Press STROBE again to turn o the strobe.
To change the switching eect of the program:
• Press FADE/SNAP on the controller.
• Fade will slowly switch the eect. Snap will rapidly switch the eect.
To black out the lights:
• Press BLACK OUT on the controller.
• This will turn o all the lights until the button is pressed again.
NOTE - The controller will not respond to any inputs when Black Out is acti-
vated. If the remote does not respond when a button is pressed, try press-
ing BLACK OUT. You may have inadvertently activated BLACK OUT.
General instruction
• Make certain that no inammable liquids, water or metal objects enter
the xture. • Do not dismantle or modify the xture. • All work must always
be carried out by qualied technical personnel. Contact the nearest sales
point for an inspection or contact the manufacturer directly. • If the unit is
to be put out of operation denitively, take it to a local recycling plant for a
disposal which is not harmful to the environment.
Description and technical specications
Infrared remote controller for projectors.
• Instant remote access to all working modes
• User-friendly control interface for easy and quick operations
• Auto mode: built-in programs with speed execution adjustment
• Sound mode: sound activation through built-in microphone with sensi-
tivity adjustment
• Manual mode: Scroll of colour macros with dimmer and strobe adjust-
ment
• Range: up to 9mt
• Battery: 3V Lithium battery (CR2025)
• Weight: 20g
• Dimensions: 100x47x7mm
Fig.1
IRC REMOTE
BLACK
OUT AUTO
STROBE SPEED
SOUND
SENSI-
TIVITY
%MANUAL FADE
SNAP
RG B
+0
123
456
7 8 9
AUV W
Table of contents
Languages:
Other ProLights Remote Control manuals
Popular Remote Control manuals by other brands

Radio Shack
Radio Shack Univer 15-2138 owner's manual

FUTABA
FUTABA 6DA instruction manual

Extron electronics
Extron electronics CTL120-3 instructions

ChronoRemoteControl
ChronoRemoteControl PROTECO NEWPRO PTX433305 How to set up

Universal Electronics
Universal Electronics CERVINO user manual

Genius
Genius AMIGO TX2 868 manual