Proline VS23 User manual

TCO
MARQUE: PROLINE
REFERENCE: VS23
CODIC: 1361546

ELECTRIC FAN
MODEL: VS23
INSTRUCTION MANUAL

WARNINGS
 This appliance is intended for domestic household use only and should not be
used for any other purpose or in any other application, such as for non-domestic
use or in a commercial environment.
 This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instructions concerning
use of the appliance by a person responsible for their safety.
 Children should be supervised to ensure that they do not play with the
appliance.
 If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
IMPORTANT SAFETY INSTRUCTIONS
 Make sure the appliance is placed on a stable surface when used.
 Do not let hair, net curtains, tablecloths or loose clothing come into contact with
the moving parts of the fan as it may cause damage or injuries.
 Do not use this fan near a window that may have condensation on it.
 Do not use this fan with any external semi-conductor speed controller.
 Do not use this fan in areas where flammable liquids are used or stored.
 The fan should be unplugged from the mains supply when not in use.
 Turn the fan off and unplug it from the mains socket before moving it from one
place to another or cleaning.
 Before any cleaning or maintenance of the fan, please switch the fan off and
remove the mains plug.

DESCRIPTION
1. Front guard
2. Fan blade
3. Locking nut
4. Rear guard
5. Motor spindle
6. Motor housing
7. Oscillation knob
8. Clip
9. Pole
10. Speed buttons
11. Base
ASSEMBLY
Make sure the fan is disconnected from the mains socket.
Rear guard assembly
Unscrew the locking nut from the fan motor.

Position the rear guard onto the motor housing; make sure the handle on the rear
guard is pointing upwards.
Screw the locking nut to tighten the rear guard to the fan motor.
Fan blade assembly
Slide the fan blade onto the motor spindle, making sure the motor spindle is fully
seated into the blade groove.
Front guard assembly
Remove the small securing screw and nut from the front
guard.
Attention! The hook of the front guard must be at the
top.
Make sure that the holes in both guards are aligned and
fasten them securely using the provided screw and nut.
Once the guard is in position fasten the clips to finally
secure both guards.
OPERATION

1. Place the fan on a stable, level surface.
2. Plug the fan in the mains socket.
3. Press the speed button to 1 or 2 to select the desired speed. To turn off the fan,
simply press switch 0.
0= Off 1= Low speed 2=High speed
4. To make the fan oscillate, push down the oscillation knob located on the top of
the motor housing and the fan will oscillate from side to side.
To stop the fan from oscillating, lift up the oscillation knob.
5. Tilting Adjustment
The airflow can be adjusted upward or downward by simply pushing the guard up
or down as required.
CLEANING AND CARE
1. Unplug the fan from the mains socket before cleaning.
2. Once the fan is assembled, it is forbidden to remove the guards.
3. Clean exterior surfaces with a damp cloth.
NOTE:
 Do not immerse the fan into water or any other liquid.
 Do not use harsh chemicals or abrasive cleaners to clean the appliance as these
may damage the surface of the appliance.
SPECIFICATIONS
Ratings: 220-240V~ 50Hz
20W
We apologise for any inconvenience caused by minor inconsistencies in these
instructions, which may occur as a result of product improvement and development.
Kesa Electricals © UK: EC1N 6TE 14 / 11 / 2012