Prorack PR3097 User manual

Page 1 of 3
09-13-520 PR3097 Rev2
Roofbox T-Bolt Kit
Item Component Qty
1T-Slot M6 x 35 mm Bolt 4
2M8 x 35 x 3 mm Washer 4
3Knob with M6 Nut 4
Kit Contents
First Time Installation
• Please read instructions carefully before installation.
• Check the contents of kit. Contact your Prorack dealer if any parts appear to be missing or damaged.
• Clean your roof racks and alloy tray prior to tting the Gas Bottle Restraint.
Important Warning
• It is critical that all Prorack racks and accessories be properly and securely attached to your vehicle. Improper
attachment could result in an automobile accident, and could cause serious bodily injury or death to you or to others.
• You are responsible for securing the racks and accessories to your car, checking the attachments prior to use, and
periodically inspecting the products for adjustment, wear, and damage.
• If you do not understand all of the instructions and cautions, or if you have no mechanical experience and are not
thoroughly familiar with the installation procedures, you should have the product installed by a professional installer
such as a roof rack specialist.
2w
13

Page 2 of 3
09-13-520 PR3097 Rev2
Instructions for Flush and Through Bar Installation
1Use keys to remove covers.
1Once the position of the roof box has been
nalised, fully tighten all red plastic knobs.
1Slide two T-bolts into each crossbar.
1Place roof box over the T-bolts and place large
washer over thread on T-bolts.
Loosely attach knobs

Page 3 of 3
09-13-520 PR3097 Rev2
Prorack
17 Hinkler Court, Brendale
QLD 4500, Australia
Freephone
AU: 1800 143 548 www.prorack.com.au
NZ: 0800 4776 722 www.prorack.co.nz
ALL CONTENT SUBJECT TO YAKIMA AUSTRALIA PTY LTD COPYRIGHT © 2015