Prorack PR3501 User manual

Number Plate Holder
Item # Component Qty
1. Back Plate 1
2. Knurled Nuts 2
3. Screws 2
4. Velcro Straps 3
Insert Velcro Straps
Take x2 Velcro Straps and thread through
the front of Number Plate Holder as shown.
Pull Velcro Straps completely through as shown.
Note:
Number Plate Holder
can also be attached to
other carriers using the
other slot combinations.
First Time Installation
• Please read instructions carefully before installation.
• Check the contents of kit. Contact your Prorack dealer if
any parts appear to be missing or damaged.
• Place these instruction in the vehicle’s glove box after
installation is complete.
Kit Contents
1
2
3
4
1
ALL CONTENT SUBJECT TO YAKIMA AUSTRALIA PTY LTD COPYRIGHT © 2018
6100010205-Rev1

Attach Number Plate Holder
Attach your assembled Number Plate
Holder to your bike carrier using the
2x Velcro Straps as shown below.
The remaining Velcro Strap can be
threaded through one of the lower slots in
Number Plate Holder to prevent swinging
if you opt to attach Number Plate Holder
to the rearmost bicycle on the carrier.
4
Prorack
17 Hinkler Court, Brendale
QLD 4500, Australia
Freephone
AU: 1800 143 548 www.prorack.com.au
NZ: 0800 4776 722 www.prorack.co.nz
ALL CONTENT SUBJECT TO YAKIMA AUSTRALIA PTY LTD COPYRIGHT © 2018
6100010205-Rev1

094RACK
BIKE RACK NUMBER PLATE
6100010205-Rev1

Position Number Plate
Position your number plate onto the Number
Plate Holder. Using the x2 Screws, line up the
Screws through slots in your number plate
with the appropriate holes in Number Plate
Holder.
Secure Number Plate
Turn Number Plate Holder over carefully
ensuring that the screws don’t fall out.
Spin the Knurled Nuts onto screw threads.
Finger tighten nuts until number plate
is secure on Number Plate Holder.
2
3
6100010205-Rev1